Chrysler PT Cruiser. Manual — part 83
Symptom:
*WINDOW DROPS OR JERKS DURING OPENING
POSSIBLE CAUSES
WINDOW MODULE
Repair Instructions:
WINDOW MODULE
Replace the Window Regulator Module in accordance with the Service Information.
Perform BODY VERIFICATION TEST - VER 1.
319
POWER WINDOWS
Symptom:
AUDIO HARDWARE MESSAGE NOT RECEIVED
When Monitored and Set Condition:
AUDIO HARDWARE MESSAGE NOT RECEIVED
When Monitored:
With the ignition on.
Set Condition:
The Hands Free Module does not receive the bus message from the radio
indicating what kind of radio the vehicle is equipped with.
POSSIBLE CAUSES
ATTEMPT TO COMMUNICATE WITH THE RADIO
MODULE
TEST
ACTION
APPLICABILITY
1
Turn the ignition on.
Turn the Radio on.
With the DRBIII
t, attempt to communicate with the Radio.
Was the DRBIII
t able to I/D or communicate with the Radio?
All
Yes
→ Go To 2
No
→ Refer to the Communication category for the related symptom(s).
Perform BODY VERIFICATION TEST - VER 1.
2
With the DRBIII
t, erase DTC’s.
Cycle the ignition switch from off to on and wait approximately 1 minute.
With the DRBIII
t, read DTC’s.
Did this DTC reset?
All
Yes
→ Replace and program the Hands Free Module in accordance with
the service information.
Perform BODY VERIFICATION TEST - VER 1.
No
→ Test Complete.
320
TELECOMMUNICATION
Symptom List:
BLUETOOTH ERROR
FLASH CHECKSUM ERROR
FLASH WRITE ERROR
PCI BUS INTERNAL ERROR
RAM WRITE ERROR
ROM CHECKSUM ERROR
Test Note:
All symptoms listed above are diagnosed using the same tests.
The title for the tests will be BLUETOOTH ERROR.
When Monitored and Set Condition:
BLUETOOTH ERROR
When Monitored:
With the ignition on.
Set Condition:
The Hands Free Module detects a fault during an internal diagnostic
check.
FLASH CHECKSUM ERROR
When Monitored:
With the ignition on.
Set Condition:
The Hands Free Module detects a fault during an internal diagnostic
check.
FLASH WRITE ERROR
When Monitored:
With the ignition on.
Set Condition:
The Hands Free Module detects a fault during an internal diagnostic
check.
PCI BUS INTERNAL ERROR
When Monitored:
With the ignition on.
Set Condition:
The Hands Free Module detects a fault during an internal diagnostic
check.
RAM WRITE ERROR
When Monitored:
With the ignition on.
Set Condition:
The Hands Free Module detects a fault during an internal diagnostic
check.
ROM CHECKSUM ERROR
When Monitored:
With the ignition on.
Set Condition:
The Hands Free Module detects a fault during an internal diagnostic
check.
321
TELECOMMUNICATION
POSSIBLE CAUSES
HFM INTERNAL DTC FAILURE
TEST
ACTION
APPLICABILITY
1
NOTE: This trouble code indicates an internal Hands Free Module fault.
With the DRBIII
t, read and record the HFM DTCs and then erase the DTCs.
Perform 5 ignition key cycles, leaving the ignition key on for a minimum of 90 seconds
per cycle.
With the DRBIII
t, read the DTCs.
Did the same DTC return?
All
Yes
→ Replace and program the Hands Free Module in accordance with
the Service Information.
Perform BODY VERIFICATION TEST - VER 1.
No
→ Test Complete.
322
TELECOMMUNICATION
BLUETOOTH ERROR —
Continued
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст