Chrysler Sebring, Stratus sedan, Sebring Convertible. Manual — part 517
Valve Spring Tester C-647
Valve Spring Compressor MD-998772-A
Valve Spring Adapter 6527
Indicator Bore Size C-119
Connecting Rod Installation Guides 8189
Main Bearing Remover/Installer C-3059
Pressure Gauge C-3292
Adapter 8406
DRB III
T
with PEP Module – OT-CH6010A
JR
ENGINE 2.7L DOHC
9 - 171
ENGINE 2.7L DOHC (Continued)
Pressure Transducer CH7059
Adaptor 8116
Cooling System Tester 7700
Combustion Leak Tester C-3685-A
9 - 172
ENGINE 2.7L DOHC
JR
ENGINE 2.7L DOHC (Continued)
AIR CLEANER ELEMENT
REMOVAL
(1) Disconnect negative battery cable.
(2) Disconnect inlet air temperature sensor electri-
cal connector (Fig. 7).
(3) Disconnect fresh air makeup hose from throttle
body air inlet hose (Fig. 8).
(4) Loosen hose clamp at throttle body (Fig. 9).
Remove hose from throttle body.
(5) Push in on locking tabs to disengage air inlet
hose from air cleaner housing. Pull air inlet hose out
far enough to disengage air cleaner element from
hose with screwdriver (Fig. 10).
(6) Remove throttle body air inlet hose.
(7) Remove air cleaner element from air cleaner
housing.
Fig. 7 INLET AIR TEMPERATURE SENSOR
Fig. 8 MAKE UP AIR HOSE
Fig. 9 HOSE CLAMP
Fig. 10 AIR FILTER TO HOSE
JR
ENGINE 2.7L DOHC
9 - 173
INSTALLATION
(1) Clean any debris from inside air cleaner hous-
ing.
(2) Install air cleaner element into air cleaner
housing (Fig. 11). Verify element rests properly on
mounting bosses inside air cleaner housing.
(3) Install throttle body air inlet hose into air
cleaner housing. Push in on hose until an audible
“click” is heard from locking tabs.
(4) Install hose on throttle body. Tighten hose
clamp (Fig. 9).
(5) Connect fresh air makeup hose (Fig. 8).
(6) Connect inlet air temperature sensor electrical
sensor (Fig. 7).
(7) Connect negative battery cable.
AIR CLEANER HOUSING
REMOVAL
(1) Disconnect negative battery cable.
(2) Disconnect inlet air temperature sensor electri-
cal connector (Fig. 12).
(3) Disconnect fresh air makeup hose from throttle
body air inlet hose (Fig. 13). Loosen clamp at throttle
body (Fig. 14).
(4) Remove hose from throttle body.
(5) Remove nut on bracket that holds air cleaner
housing.
(6) Pull air cleaner housing straight up off of locat-
ing pins.
Fig. 11 AIR FILTER IN HOUSING
Fig. 12 INLET AIR TEMPERATURE SENSOR
Fig. 13 MAKE UP AIR HOSE
9 - 174
ENGINE 2.7L DOHC
JR
AIR CLEANER ELEMENT (Continued)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст