Chrysler Le Baron, Dodge Dynasty, Plymouth Acclaim. Manual — part 105
EXTENSION HOUSING
Fig. 1 Remove Extension Seal
Fig. 2 Install New Seal into Extension
Fig. 3 Remove Extension Bearing Cup
Fig. 4 Extension
Fig. 5 Install Extension Oil Baffle
Fig. 6 Install Extension Bearing Cup
Ä
TRANSAXLE
21 - 25
INPUT SHAFT
Shim thickness need only be determined if any of
the following parts are replaced:
• Transaxle case
• Input shaft seal retainer
• Bearing retainer plate
• Rear end cover
• Input shaft
• Input shaft bearings
Refer to Bearing Adjustment Procedure in rear
of this section to determine proper shim thickness for
correct bearing end play and proper turning torque.
Fig. 1 Remove Input Shaft Rear Bearing Cone
Fig. 2 Install Input Shaft Rear Bearing Cone
Fig. 3 Remove Input Shaft Front Bearing Cone
Fig. 4 Install Input Shaft Front Bearing Cone
Fig. 5 Remove Input Shaft Rear Bearing Cup
21 - 26
TRANSAXLE
Ä
CAUTION: Bolt on bearing support plate before in-
stalling input shaft rear bearing cup.
A-523, A-543 DIFFERENTIAL
Shim thickness need only be determined if any of
the following parts are replaced:
• Transaxle case
• Differential bearing retainer
• Extension housing
• Differential case
• Differential bearings
CAUTION: Differential covers are not interchange-
able from case to case.
Refer to Bearing Adjustment Procedure in rear
of this section to determine proper shim thickness for
correct bearing preload and proper bearing turning
torque.
Fig. 6 Install Input Shaft Rear Bearing Cup
Fig. 1 Remove Differential Bearing Cone
Fig. 2 Install Differential Bearing Cone
Fig. 3 Remove Differential Bearing Cone
Fig. 4 Install Differential Bearing Cone
Ä
TRANSAXLE
21 - 27
CAUTION: Always install new ring gear bolts. Bolts
must be properly torqued (See Tightening Refer-
ence).
After assembling the differential side gears, pinion
gears and pinion gears with the pinion gear washers,
but without the side gear thrust washers. Rotate the
assembly two full revolutions both clockwise and
counterclockwise.
Set up dial indicator as shown and record end play.
Rotate side gear 90 degrees and record another end
play. Again, rotate side gear 90 degrees and record a
final end play.
Using the smallest end play recorded, shim that
side gear to within .001 to .013 inch. The other side
gear should be checked using the same procedure.
Fig. 5 Remove or Install Ring Gear Bolts and Ring
Gear
Fig. 6 Remove Pinion Shaft Roll Pin
Fig. 7 Remove or Install Pinion Shaft
Fig. 8 Remove or Install Pinion Gears, Side Gears,
and Thrust Washers by Rotating Side Gears to
Opening in Case
Fig. 9 Differential Gears
21 - 28
TRANSAXLE
Ä
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст