Chrysler Le Baron, Dodge Dynasty, Plymouth Acclaim. Manual — part 306
Fig. 29 Electronic Cluster Self-Diagnostic Test
Ä
INSTRUMENT PANEL AND GAUGES
8E - 35
Fig. 30 Electronic Cluster Self-Diagnostic Test Continued
8E - 36
INSTRUMENT PANEL AND GAUGES
Ä
CONDITION: US/METRIC MODES WILL NOT
TOGGLE OR TRIP ODOMETER WILL NOT
RESET
PROCEDURE
(1) Perform cluster self-diagnostics to determine if
push buttons are operational.
(2) Refer to the Body Chassis Diagnostic Manual
to diagnose CCD Bus. The US/Metric toggle and trip
odometer reset are activated over the CCD Bus.
ODOMETER ADJUSTMENT
The odometer memory is no longer retained in the
cluster. This information is stored in the body con-
troller. Therefore, there is no adjustment procedure.
If the cluster is replaced odometer value will not
change. If the body controller is replaced the mileage
may be transferred using the DRB II. Refer to the
Body Chassis Diagnostic Manual for the procedure.
SWITCH AND PANEL COMPONENT SERVICE
MESSAGE CENTER REPLACEMENT
(1) Remove upper cluster bezel (Fig. 32).
(2) Remove two attaching screws (Fig. 33).
(3) Disconnect wiring connector and remove mes-
sage center.
(4) For installation reverse above procedures.
AIR CONDITIONING CONTROL
REPLACEMENT
(1) Remove upper cluster bezel (Fig. 32).
(2) Remove two control mounting screws.
Fig. 31 Cluster Connector
Fig. 32 Cluster Bezel
Ä
INSTRUMENT PANEL AND GAUGES
8E - 37
(3) Slide control rearward, disconnect cable, vac-
uum harness and electrical wiring (Fig. 34).
(4) Remove control.
(5) For installation reverse above procedures.
AUTOMATIC TEMPERATURE CONTROL LAMP
REPLACEMENT
(1) Remove automatic temperature control from in-
strument panel.
(2) Remove top cover screw and unsnap cover from
control (Fig. 35).
(3) Remove four screws that connect computer
housing to the button housing.
(4) Unsnap the button housing from the computer
housing.
(5) Remove lamps by turning in a counter clock-
wise direction and install lamps by turning in a
clockwise direction.
(6) For
installation
reverse
above
procedures.
When finish perform ATC system function test.
HEADLAMP AND ACCESSORY SWITCH
MODULE REPLACEMENT
(1) Remove cluster bezel (Fig. 32).
(2) Remove four screws attaching module to instru-
ment panel (Fig. 36).
(3) Disconnect all wiring connectors to remove
module.
(4) For installation reverse above procedures.
HEADLAMP SWITCH REPLACEMENT
(1) Remove headlamp and accessory switch module
from instrument panel (Fig. 36).
(2) Press button on underside of headlamp switch
and pull knob and shaft to remove.
Fig. 33 Message Center
Fig. 34 A/C Control
Fig. 35 Automatic Temperature Control Lamp
Fig. 36 Headlamp and Accessory Switch Module
8E - 38
INSTRUMENT PANEL AND GAUGES
Ä
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст