Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 1730
47. Route front parking brake cable with equalizer
above rear crossmember.
NOTE: Due to short travel and low spring tension,
it is not necessary to lock-out parking brake lever
to service parking brake components.
48. Connect left rear parking brake cable (1) to equal-
izer (2).
49. Connect right rear parking brake cable (4) to con-
nector (3) already attached to front parking brake
cable (5).
50. Install J-nut for mounting parking brake cable
routing bracket to crossmember.
51. Insert front parking brake cable routing bracket
locating pin into front flange of crossmember (3),
then install screw (2) fastening cable (1) routing
bracket to rear crossmember.
52. On each side of vehicle, slide an axle half shaft
(2) through hub and bearing and install hub nut
(1). Do not tighten hub nuts at this time.
13 - 120
FRAME & BUMPERS
LX
53. Install rear axle differential. (Refer to 3 - DIFFERENTIAL & DRIVELINE/REAR AXLE - 198MM - INSTALLA-
TION) (Refer to 3 - DIFFERENTIAL & DRIVELINE/REAR AXLE - 210MM - INSTALLATION) (Refer to 3 - DIF-
FERENTIAL & DRIVELINE/REAR AXLE - 215RII - INSTALLATION)
54. While a helper applies brakes to keep hub from
turning, tighten hub nut to 213 N·m (157 ft. lbs.).
55. Install
rear
exhaust
system
(2)
(dual-outlet
exhaust shown in figure). (Refer to 11 - EXHAUST
SYSTEM - INSTALLATION)
LX
FRAME & BUMPERS
13 - 121
56. Lower vehicle until front tires contact floor but rear
is still suspended. Place jack stands under each
rear suspension spring link. Place an appropriate
wooden block between stand and link to avoid
damaging spring link, then lower vehicle until full
vehicle weight is supported by suspension.
57. Tighten camber link bolt (2) at crossmember to 85
N·m (63 ft. lbs.).
58. Tighten tension link bolt nut (2) at crossmember to
85 N·m (63 ft. lbs.).
59. Tighten compression link bolt (2) at crossmember
to 85 N·m (63 ft. lbs.) torque.
13 - 122
FRAME & BUMPERS
LX
60. Tighten spring link bolt (1) at crossmember to 108
N·m (80 ft. lbs.).
61. Tighten shock absorber lower mounting bolt nut
(4) to 72 N·m (53 ft. lbs.).
62. Tighten stabilizer link bolts (3) to 61 N·m (45 ft.
lbs.).
LX
FRAME & BUMPERS
13 - 123
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст