Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 1841
6. If equipped with electronic telescoping column,
install the electric tilt lever and switch (3).
7. If equipped with ESP, install the steering angle
sensor and screw (3) located at the six o’clock
position.
8. Install the clockspring and screws (1) leaving one
out so it will not unwind.
9. Install the SCCM on the steering column, (Refer to
19 - STEERING/COLUMN/STEERING COLUMN
CONTROL MODULE - INSTALLATION) and tighten
the one clockspring screw (1) that was left loose.
19 - 182
COLUMN SERVICE INFORMATION
LX
INSTALLATION
1. Install the SCCM (1) onto the steering column.
2. Tighten the set screw (1) securing the SCCM (2).
3. Tighten clockspring screw(s) (1) that were backed
out to keep the clockspring from unwinding.
LX
COLUMN SERVICE INFORMATION
19 - 183
4. Align the spline on the steering wheel hub to shaft
and install the steering wheel (1).
5. Install a NEW retaining bolt (2). Torque the bolt to
70 N·m (52 ft. lbs.).
6. Install the driver airbag (3) (Refer to 8 - ELECTRI-
CAL/RESTRAINTS/DRIVER AIRBAG - INSTALLA-
TION).
7. Connect the battery negative cable. If equipped
with Electronic Stability Program (ESP), the steer-
ing angle sensor must be calibrated (Refer to 8 -
ELECTRICAL/BATTERY SYSTEM - STANDARD
PROCEDURE).
19 - 184
COLUMN SERVICE INFORMATION
LX
SHROUD
REMOVAL
The steering column shroud is part of the steering column control module (SCCM). Remove and disassemble the
SCCM. (Refer to 19 - STEERING/COLUMN/STEERING COLUMN CONTROL MODULE - REMOVAL) (Refer to 19
- STEERING/COLUMN/STEERING COLUMN CONTROL MODULE - DISASSEMBLY)
INSTALLATION
The steering column shroud is part of the steering column control module (SCCM). (Refer to 19 - STEERING/COL-
UMN/STEERING COLUMN CONTROL MODULE - ASSEMBLY)
LX
COLUMN SERVICE INFORMATION
19 - 185
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст