Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 1842
SHROUD-ROLL TOP
REMOVAL
WARNING: Before servicing the steering column the airbag system must be disarmed. Refer to electrical
restraint system for service procedures. Failure to do so may result in accidental deployment of the airbag
and possible personal injury or death.
CAUTION: All fasteners must be torqued to specification to ensure proper operation of the steering column.
1. Position the front wheels straight-ahead.
2. Fully extend or pull out adjustable steering column.
3. Disconnect the negative (ground) cable from the
battery.
4. Remove the driver airbag (3). (Refer to 8 - ELEC-
TRICAL/RESTRAINTS/DRIVER
AIRBAG
-
REMOVAL)
5. Remove the steering wheel retainer bolt (2), then
slide the steering wheel (1) off the column shaft.
19 - 186
COLUMN SERVICE INFORMATION
LX
6. Remove at least one clockspring screw (1), (Refer
to 8 - ELECTRICAL/RESTRAINTS/CLOCKSPRING
- REMOVAL). This will help keep the clockspring
from becoming uncentered.
7. Back out the set screw (1) through the access hole
(3) in the bottom of the Steering Column Control
Module (SCCM) (2).
8. Pull the SCCM (1) off the steering column shaft.
LX
COLUMN SERVICE INFORMATION
19 - 187
9. Remove the steering column opening cover (1) (Refer to 23 - BODY/INSTRUMENT PANEL/STEERING COL-
UMN OPENING COVER - REMOVAL).
10. Remove the steering column opening reinforce-
ment (1).
11. Remove the cluster bezel. (Refer to 23 - BODY/
INSTRUMENT
PANEL/CLUSTER
BEZEL
-
REMOVAL)
19 - 188
COLUMN SERVICE INFORMATION
LX
12. Manual tilt and telescoping columns – Unsnap
and move the adjustment handle locking tab (3)
forward as shown unlatching the handle (2) from
the column.
13. Remove the four (three for column shift column)
shroud mounting screws (2).
14. Remove the roll top shroud (1) along with manual
tilt/telescope handle (3) (if equipped).
LX
COLUMN SERVICE INFORMATION
19 - 189
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст