Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 1727
38. On each side of crossmember, remove bolt and
nut (1) mounting link (3) at crossmember.
39. On each side of crossmember, remove nut and
bolt (4) mounting tension link to crossmember (1).
40. On each side of crossmember, remove nut and
bolt (2) mounting camber link to crossmember (1).
41. Carefully lift knuckle with links and parking brake
cable attached from rear suspension crossmem-
ber.
42. Remove crossmember from jack.
13 - 108
FRAME & BUMPERS
LX
INSTALLATION
1. Install rear crossmember (1) on jack (2) head in
same position in which it was removed and secure
in place.
2. Carefully place one side knuckle with links and
parking brake cable attached as an assembly into
mounted position on rear suspension crossmem-
ber. Install nut and bolt (2) mounting camber link to
crossmember (1) to hold assembly in place. Do
not tighten at this time.
3. Carefully place opposite side knuckle with links and
parking brake cable attached as an assembly into
mounted position on rear suspension crossmem-
ber. Install nut and bolt (2) mounting camber link to
crossmember (1) to hold assembly in place. Do
not tighten at this time.
4. On each side of crossmember, install nut and bolt
(4) mounting each tension link to crossmember (1).
Do not tighten at this time.
LX
FRAME & BUMPERS
13 - 109
5. On each side of crossmember, Install bolt and nut
(1) mounting each compression link (3) at cross-
member. Do not tighten at this time.
6. On each side of crossmember, slide cam bolt (2)
attaching toe link through crossmember and link (1)
from rear.
7. On each side of crossmember, while holding toe
adjustment cam bolt from rotating, install cam
washer (2) and nut (3) securing toe link at cross-
member (1). Do not tighten at this time.
13 - 110
FRAME & BUMPERS
LX
8. On each side of crossmember, install bolt and nut
(1) fastening spring link (4) to crossmember. Do
not tighten at this time.
9. On each side of crossmember rear, guide leading
end of rear parking brake through crossmember
bracket (1 - left)(2 - right) near equalizer and press
cable housing retainer into bracket allowing retainer
fingers to lock cable in place.
10. On each side of crossmember rear, install J-nut
for parking brake cable guide.
11. On each side, install screw fastening parking
brake cable routing guide (1) to crossmember.
LX
FRAME & BUMPERS
13 - 111
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст