Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 1726
25. Position under-hoist utility jack or transmission
jack (2) under center of rear crossmember (1).
Raise jack head to contact crossmember and
secure in place. When securing crossmember
to jack, be sure not to secure stabilizer bar.
WARNING: Before opening fuel system, review all
Warnings and Cautions.
26. Remove fuel filler tube. (Refer to 14 - FUEL SYS-
TEM/FUEL DELIVERY/FUEL TANK FILLER TUBE
- REMOVAL)
NOTE: If equipped with AWD, when removing
crossmember mounting bolts in following step, be
sure to not to misplace spacers (1) between cross-
member mounts (2) and body.
13 - 104
FRAME & BUMPERS
LX
27. Remove both front (3) and both rear (2) mounting
bolts fastening crossmember (1) in place.
28. Slowly lower crossmember using jack until crossmember is at a comfortable working level to access link and
stabilizer bar fasteners.
29. On each end, remove bolt (3) and nut fastening
stabilizer bar (4) to stabilizer link (2).
30. Remove bolts (1) fastening each stabilizer bar
cushion retainer to crossmember.
31. Remove stabilizer bar (4) with cushions and
retainers.
LX
FRAME & BUMPERS
13 - 105
32. Remove coil springs and isolators (1, 2 and 5)
from spring links.
33. For each parking brake cable, place 13 mm
12-point box wrench (4) over cable strand and
completely onto cable retainer (3) as shown at
crossmember bracket (1 - left)(2 - right). It may be
necessary to wiggle wrench around somewhat to
collapse retainer fingers. With wrench in place,
pull cable from bracket.
34. On each side, remove screw fastening parking
brake cable routing guide (1) to crossmember.
Remove J-nuts from crossmember.
13 - 106
FRAME & BUMPERS
LX
NOTE: For installation purposes, when removing
fasteners for any rear suspension links, it is
important to note which bolt fastens what compo-
nent and in what direction it is installed in.
35. On each side of crossmember, remove bolt and
nut (1) fastening spring link (4) to crossmember.
36. On each side of crossmember, while holding toe
adjustment cam bolt from rotating, remove nut (3)
securing toe link at crossmember (1).
37. On each side of crossmember, slide cam bolt (2)
attaching toe link rearward, out of crossmember
and link (1).
LX
FRAME & BUMPERS
13 - 107
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст