Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 1701
BUMPER-REAR
REMOVAL
NOTE: 300 Shown. Magnum and Charger similar.
1. Remove the fascia assembly. (Refer to 13 -
FRAME & BUMPERS/BUMPERS/FASCIA-REAR -
REMOVAL)
2. Remove the six nuts and washers and remove the
bumper.
INSTALLATION
1. Position the bumper.
2. Install the nuts and washers and tighten to 28 N·m
(21 ft. lbs.).
3. Install the fascia assembly. (Refer to 13 - FRAME
& BUMPERS/BUMPERS/FASCIA-REAR - INSTAL-
LATION)
13 - 4
FRAME & BUMPERS
LX
FASCIA-FRONT
REMOVAL
1. Raise and support the vehicle.
2. Remove the three push-pin retainers (1) that
secure each front wheel house splash shield (2) to
the front fascia assembly (3).
3. Remove the nine screws (1) that secure the belly pan (2) to the underbody.
NOTE: 300 Shown. Magnum and SRT8 similar
LX
FRAME & BUMPERS
13 - 5
4. Remove the screw (5) that secures the front fascia
assembly (4) to the nut insert (1) in each front
fender.
5. Partially lower the vehicle and remove the push-pin
retainers (2) (four-sedan, six-wagon, eight-Charger)
that secure the front fascia assembly to the upper
radiator support.
6. If equipped, disconnect the headlamp washer sys-
tem hose from washer reservoir. (Refer to 8 -
ELECTRICAL/WIPERS/WASHERS/HEADLAMP
WASHER - REMOVAL)
7.
On all three SRT8 models, disconnect the Tire
Pressure Monitoring System connector. (Refer to
22 - TIRES/WHEELS/TIRE PRESSURE MONI-
TORING/TRANSPONDER - REMOVAL)
8. Carefully pull the front fascia assembly forward to
disengage the push-pin retainer (6) from the slot in
each side the fascia and position the fascia to gain
access to the fog lamp wire harness connectors (3), if equipped.
Charger
1. Remove the screw (6) that secures the front fascia assembly (5) to the nut insert (1) in each front fender.
2. Partially lower the vehicle and remove the push-pin retainers (4) (four-sedan, six-wagon, eight-Charger) that
secure the front fascia assembly to the upper radiator support.
3. Carefully pull the front fascia assembly forward to disengage the push-pin retainer (6) from the slot in each side
the fascia and position the fascia to gain access to the fog lamp wire harness connectors (7), if equipped.
13 - 6
FRAME & BUMPERS
LX
9. If equipped, disconnect each fog lamp wire harness
connector (1) from the headlamp wire harness (2)
and remove the front fascia assembly (3) from the
vehicle.
10. If equipped and if required, remove the fog lamps
from the front fascia assembly (Refer to 8 -
ELECTRICAL/LAMPS/LIGHTING
-
EXTERIOR/
LAMP-FOG - REMOVAL).
11. If required on SRT8 models, remove the lower
fascia from the front fascia assembly and discard
the metal retaining clips.
12. If required, remove and discard the nut insert (1)
from each front fender and remove the push-pin
retainer (2).
LX
FRAME & BUMPERS
13 - 7
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст