Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 1702
INSTALLATION
1. If removed, install the push-pin retainer (2) and a
new nut insert (1) into each front fender.
NOTE: 300 Shown. Magnum and SRT8 similar.
2. If removed on SRT8 models, install the lower fascia
onto the front fascia assembly (4) using new metal
retaining clips.
3. If equipped and removed, install the fog lamps onto
the front fascia assembly (Refer to 8 - ELECTRI-
CAL/LAMPS/LIGHTING - EXTERIOR/LAMP-FOG -
INSTALLATION).
4. Position the front fascia assembly to the vehicle
and connect each fog lamp wire harness connector
(3), if equipped.
5. If equipped, connect the headlamp washer system
hose to washer reservoir. (Refer to 8 - ELECTRI-
CAL/WIPERS/WASHERS/HEADLAMP WASHER -
INSTALLATION)
6. On all three SRT8 models, connect the Tire Pres-
sure Monitoring connector. (Refer to 22 - TIRES/
WHEELS/TIRE
PRESSURE
MONITORING/
TRANSPONDER - REMOVAL)
7. Engage the push-pin retainer (6) into the slot in each side of the front fascia assembly by pushing the fascia
rearward.
8. Install the push-pin retainers (2) (four-sedan, six-wagon, eight Charger) that secure the front fascia assembly to
the upper radiator support.
9. Raise and support the vehicle.
10. Install the screw (5) that secures the front fascia assembly to the nut insert (1) in each front fender. Tighten the
screws securely.
11. Position belly pan to front of vehicle. Install and tighten screws.
13 - 8
FRAME & BUMPERS
LX
Charger
1. Install the screw (6) that secures the front fascia assembly (5) to the nut insert (1) in each front fender.
2. Partially lower the vehicle and install the push-pin retainers (4) (four-sedan, six-wagon, eight-Charger) that
secure the front fascia assembly to the upper radiator support.
3. Carefully pull the front fascia assembly rearward to engage the push-pin retainer (6) from the slot in each side
the fascia and position the fascia to gain access to the fog lamp wire harness connectors (7), if equipped.
12. Position the belly pan (1) to the front of the vehi-
cle underbody and install the nine screws (1).
Tighten the screws securely.
LX
FRAME & BUMPERS
13 - 9
13. Position each front wheel house splash shield (2)
to the front fascia assembly (3) and install the
push-pin retainers (1).
14. Lower the vehicle.
13 - 10
FRAME & BUMPERS
LX
FASCIA-REAR
REMOVAL
1. Raise and support the vehicle.
2. Remove the three push-pin retainers (1) that
secure each rear wheel house splash shield (2) to
the rear fascia assembly (3).
3. Remove the screw (2) that secures the rear fascia
assembly (3) to the nut insert (1) in each quarter
panel.
LX
FRAME & BUMPERS
13 - 11
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст