Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 517
2. From the underside of the headlamp unit, remove
the six retaining screws (1).
3. Pull the ballast module out of headlamp unit.
4. Disconnect the cable connector (2) Move the lever
away or down from the wire of the cable and
connector.
5. Remove the rubber boot (1) protecting the lamp/ig-
niter from the elements.
8L - 98
LAMPS/LIGHTING - EXTERIOR - SERVICE INFORMATION
LX
6. Disconnect the electrical cable connector to the
lamp/igniter by pulling straight down.
7. Maneuver
cable
through
headlamp
unit
to
separate.
LX
LAMPS/LIGHTING - EXTERIOR - SERVICE INFORMATION
8L - 99
INSTALLATION
HALOGEN HEADLAMP
1. Twist lamp (1 or 2) into headlamp housing clock-
wise.
2. Connect the lamp electrical connector.
3. Connect the battery negative cable.
NOTE: If replacing the left low or high beam head-
lamp, the air box has to be reinstalled (Refer to 9 -
ENGINE/AIR INTAKE SYSTEM - INSTALLATION).
HIGH INTENSITY DISCHARGE (HID) HEADLAMPS (IF EQUIPPED) - LOW BEAM
HEADLAMP
1. Push the igniter straight into the headlamp unit with
the connector pointing straight down. The lamp is
integral to the igniter.
2. Put the retaining wire clip on the back of the
lamp/igniter.
8L - 100
LAMPS/LIGHTING - EXTERIOR - SERVICE INFORMATION
LX
3. Connect the electrical cable connector to the
lamp/igniter.
4. Install the rubber boot (1) protecting the lamp/ig-
niter from the elements.
5. Connect the battery negative cable.
NOTE: If replacing the left low beam headlamp, the
air box has to be reinstalled (Refer to 9 - ENGINE/
AIR INTAKE SYSTEM - INSTALLATION).
LX
LAMPS/LIGHTING - EXTERIOR - SERVICE INFORMATION
8L - 101
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст