Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 102
NOTE: Due to axle imbalance concerns, it is nec-
essary to make sure pinion flange-to-shaft orienta-
tion is maintained. If alignment marks are not
visible, apply appropriate marks before removing
pinion flange.
4. Using puller 1026 (1), remove pinion flange (2)
from pinion shaft.
5. Using suitable tool (1), remove pinion seal (2) and
discard.
3 - 140
REAR AXLE - 198RII
LX
INSTALLATION
1. Apply light coating of gear lubricant to the lip of the
pinion seal.
2. Using Tool 9231A (1), install pinion seal until tool
bottoms on carrier.
3. Install pinion flange into position. Align index marks
to maintain assembly balance.
4. Using Installer 6448A (1), lightly tap on pinion
flange (2) until adequate pinion shaft threads are
exposed.
LX
REAR AXLE - 198RII
3 - 141
5. Install new pinion flange nut. Using flange holder
tool C-3281(1) and 41mm socket, torque nut to 136
N·m (100 ft. lbs.).
6. Measure assembly turning torque. Axle assembly
rotating torque must be should be equal to the
reading recorded upon seal/flange removal.
7. If rotating torque is low, increase pinion flange nut
torque in 7 N·m (5 ft. lbs.) increments. Repeat until
proper rotating torque is received.
3 - 142
REAR AXLE - 198RII
LX
8. Stake pinion flange nut (1) as shown.
9. Install rear axle assembly. Refer to Rear Axle
Installation.
LX
REAR AXLE - 198RII
3 - 143
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст