Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 101
Installer, C-3095-A
Flange Wrench, C-3281
Dial Indicator Set, C-3339-A
Handle, C-4171
Installer, C-4310
Installer, D-146
Remover, D-149
Adapter, SP-3289
Spreader, W-129-B
3 - 136
REAR AXLE - 198RII
LX
SEAL-AXLE SHAFT
REMOVAL
1. Remove halfshaft(s). (Refer to 3 - DIFFERENTIAL
& DRIVELINE/HALF SHAFT - REMOVAL)
2. Using suitable screwdriver (1), remove axle shaft
seal (2).
3. Visually inspect halfshaft seal journal for damage
(excessive seal groove, nicks, scratches, etc.
Replace halfshaft if necessary.
INSTALLATION
1. Using Tool 9223 (2), install NEW axle shaft seal
(1). Lubricate the inside diameter with Mopar
T
Gear and Axle Lubricant 75W-140 to protect seal
during halfshaft installation.
2. Install halfshaft(s). (Refer to 3 - DIFFERENTIAL &
DRIVELINE/HALF SHAFT - INSTALLATION)
LX
REAR AXLE - 198RII
3 - 137
3. Remove fill plug (1) to check and adjust rear axle
fluid level. Top off axle with Mopar
T
Gear and Axle
Lubricant 75W-140. Reinstall fill plug torque to 60
N·m (44 ft. lbs.) torque.
3 - 138
REAR AXLE - 198RII
LX
SEAL-PINION FLANGE
REMOVAL
1. Remove rear axle assembly from vehicle. Refer to
Rear Axle Removal.
2. Measure axle assembly rotating torque and record
measurement for reuse on assembly.
3. Using flange holder C-3281(1) and 41mm socket,
remove pinion flange nut and discard.
LX
REAR AXLE - 198RII
3 - 139
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст