Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 1550
MOUNT - RIGHT
REMOVAL
1. Disconnect the negative battery cable.
2. Raise and support the vehicle.
3. Remove both of the engine mount to cradle nuts.
4. Remove both of the engine mount through studs.
5. Using a suitable jack stand and a block of wood
positioned under the oil pan, raise the engine until
the weight is off of the mounts (approximately 5
mm.).
6. Remove the right mount heat shield (2) bolts.
7. Remove the engine mount (2).
9 - 2224
ENGINE - 3.5L - SERVICE INFORMATION
LX
INSTALLATION
1. Install the engine mount to the engine bracket and
hand tighten . Tighten bolts to 54 N·m (40 lbs. ft.).
2. Install and hand tighten the engine mount through
studs.
3. Tighten the engine mount to engine bracket fasten-
ers to 75 N·m (55 lbs. ft.).
4. Install the engine mount heat shield (2). Tighten the
fasteners to 11 N·m (97 in. lbs.).
5. Lower the engine and remove the lifting devise.
6. Tighten the engine mount through studs to 12 N·m
(106 in. lbs.).
7. Install the right engine mount to cradle nuts and
tighten both engine mount fasteners to 75 N·m (55
lbs. ft.).
8. Lower the vehicle.
9. Connect the negative battery cable.
LX
ENGINE - 3.5L - SERVICE INFORMATION
9 - 2225
MOUNT RIGHT - AWD
REMOVAL
1. Disconnect the negative battery cable.
2. Raise and support the vehicle.
3. Remove the right front wheel.
4. Place a jack stand under the engine.
5. Remove the engine mount to cradle fastener.
6. Raise the engine with the jack stand and support
the engine weight.
7. Remove the engine mount bolts and the engine
mount.
INSTALLATION
1. Carefully position the engine mount and hand
tighten the mount retaining bolts.
2. Tighten the engine mount to bracket bolts to 60
N·m (44 lbs. ft.).
3. Lower the engine onto the cradle and remove the
jack stand.
4. Tighten the engine mount to cradle bolt to 75 N·m
(55 lbs. ft.).
5. Install the right front wheel.
6. Lower the vehicle.
7. Connect the negative battery cable.
9 - 2226
ENGINE - 3.5L - SERVICE INFORMATION
LX
MOUNT - REAR
REMOVAL
1. Raise vehicle on hoist.
2. Remove cross member to mount bolts (2).
3. Place transmission jack under transmission pan
and raise transmission.
4. Remove cross member attaching bolts and remove
cross member (1).
5. Remove mount to transmission bolts (2), remove
mount (1).
LX
ENGINE - 3.5L - SERVICE INFORMATION
9 - 2227
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст