Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 1472
6. Remove accessory drive belt (5) (Refer to 7 -
COOLING/ACCESSORY DRIVE/DRIVE BELTS -
REMOVAL).
7. Disconnect lines from power steering pump (3).
8. Remove power steering pump attaching bolts and
set pump aside (3).
9. Recover A/C system using a suitable refrigerant
recovery machine (Refer to 24 - HEATING & AIR
CONDITIONING/PLUMBING - STANDARD PRO-
CEDURE).
10. Disconnect A/C compressor (4) electrical connec-
tors.
11. Remove A/C compressor (4) (Refer to 24 - HEAT-
ING
&
AIR
CONDITIONING/PLUMBING/A/C
COMPRESSOR - REMOVAL).
12. Raise vehicle.
13. Remove lower splash shield bolts (1) and remove
splash shield (2).
14. Drain cooling system (Refer to 7 - COOLING/EN-
GINE - STANDARD PROCEDURE).
15. Drain the engine oil (5) and remove the oil filter
(3).
16. Disconnect down stream oxygen sensor connec-
tors.
17. Disconnect exhaust pipes at the manifolds.
9 - 1912
ENGINE - 2.7L DOHC - SERVICE INFORMATION
LX
18. Disconnect starter (2) electrical connectors.
19.
Remove starter (2) bolts and set starter aside.
20. Disconnect coolant pipe (1) near starter from
hose.
21. Disconnect crankshaft position sensor electrical
connector and remove sensor (Refer to 14 -
FUEL SYSTEM/FUEL INJECTION/CRANKSHAFT
POSITION SENSOR - REMOVAL).
22. Disconnect ground strap.
23. Disconnect oil pressure sensor (1) electrical con-
nector.
LX
ENGINE - 2.7L DOHC - SERVICE INFORMATION
9 - 1913
24. Remove 4 engine mount nuts (1).
25. Remove engine mount studs (1) from mount.
26. Remove steering gear mounting bolts (1) and
lower steering gear (2) for clearance.
27. Using a block of wood and a suitable lifting device
under the oil pan, raise the engine.
28. Remove structural collar bolts (2 & 4).
29. Remove structural collar (3).
30. Remove lower bell housing bolts.
31. Lower engine and remove jack stand.
32. Mark flex plate to torque converter location.
33. Remove torque converter bolts.
34. Lower vehicle.
9 - 1914
ENGINE - 2.7L DOHC - SERVICE INFORMATION
LX
35. Remove wiper arms (Refer to 8 - ELECTRICAL/
WIPERS/WASHERS/WIPER ARMS - REMOVAL).
36. Remove wiper cowl (1) (Refer to 8 - ELECTRI-
CAL/WIPERS/WASHERS/WIPER
MODULE
-
REMOVAL).
37. Remove strut tower support (2).
38. Reposition purge solenoid (5).
39. Remove the intake manifold (2) (Refer to 9 -
ENGINE/MANIFOLDS/INTAKE
MANIFOLD
-
REMOVAL).
40. Disconnect all vacuum lines and electrical con-
nectors.
41. Disconnect all ground straps attaching to the
engine.
LX
ENGINE - 2.7L DOHC - SERVICE INFORMATION
9 - 1915
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст