Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 1473
42. Disconnect fuel line at fuel rail (1).
43. Disconnect coil, injector (2), capacitor, and knock
sensor connectors.
44. Remove EGR valve and tube assembly (Refer to
25 - EMISSIONS CONTROL/EXHAUST GAS
RECIRCULATION/VALVE - REMOVAL).
45. Remove upper bellhousing bolts and reposition
electrical harness.
9 - 1916
ENGINE - 2.7L DOHC - SERVICE INFORMATION
LX
46. Attach special tool #8342A (1).
a. Attach special tool #8342A to the front of the left cylinder head (2).
b. Attach special tool #8342A to the rear of the right cylinder head (3).
47. Support transmission with a block of wood and floor jack.
48. Hoist engine from engine compartment.
LX
ENGINE - 2.7L DOHC - SERVICE INFORMATION
9 - 1917
INSTALLATION - ENGINE ASSEMBLY
1. Attach special tool #8342A engine lifting fixture (1).
a. Attach special tool #8342A to the front of the left cylinder head (2).
b. Attach special tool #8342A to the rear of the right cylinder head (3).
2. Lower engine into engine compartment.
3. Remove special tool #8342A (1).
CAUTION: Do not tighten the transmission case to engine block bolts until all bolts have been hand started,
and the two mating surfaces are completely joined together, as damage to cylinder block or transmission
could occur.
4. Install bell housing to cylinder block bolts and tighten to 68 N·m (50 ft. lbs.).
9 - 1918
ENGINE - 2.7L DOHC - SERVICE INFORMATION
LX
5. Install EGR valve and tube assembly (Refer to 25 - EMISSIONS CONTROL/EXHAUST GAS RECIRCULATION/
VALVE - INSTALLATION).
6. Connect coil, injector (2), capacitor, and knock sen-
sor connectors.
7. Connect the fuel line (1).
8. Install upper intake manifold (Refer to 9 - ENGINE/
MANIFOLDS/INTAKE
MANIFOLD
-
INSTALLATION).
9. Install purge solenoid (5).
10. Connect all ground straps.
11. Connect
all
vacuum
lines
and
electrical
connectors.
LX
ENGINE - 2.7L DOHC - SERVICE INFORMATION
9 - 1919
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст