Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 2145
INSTALLATION
1. Check to be certain that the ball stud (3) on the top
of the fender load beam is in good condition and
properly installed. Tighten the ball stud to 28 N·m
(21 ft. lbs.).
2. Position the ball socket on the rod end of the sup-
port cylinder (1) to the ball stud on the top of the
fender load beam.
3. Check to be certain that the ball stud (1) secured
by a U-nut (3) to the upper bracket (2) of the hood
hinge is in good condition and properly installed.
Tighten the ball stud to 28 N·m (21 ft. lbs.).
4. Position the ball socket on the cylinder end of the
support cylinder (4) to the ball stud on the upper
bracket of the hood hinge.
5. Using hand pressure, press the ball socket onto
the ball stud until the retainer clip snaps into place.
6. Inspect to be certain that the retaining clip on each
of the support cylinder ball socket ends is fully
seated.
7. Remove the service prop or block and close the
hood.
23 - 128
HOOD
LX
AIR INLET- FRESH AIR DUCT
REMOVAL
NOTE: On SRT 8 models only.
1. Remove hood liner.
2. Remove push pins (2) and remove air inlet (1) from
hood (2).
INSTALLATION
NOTE: On SRT 8 models only.
1. Place air inlet (1) to hood (2).
2. Insert push pins (3) fastening air inlet to hood.
3. Install hood liner and push pins.
LX
HOOD
23 - 129
HOOD-BEZEL
REMOVAL
NOTE: On SRT 8 models only.
1. Using special tool C-4755, release tabs securing
bezel (1) to hood (2).
2. Remove bezel (1).
INSTALLATION
NOTE: On SRT 8 models only.
1. Insert top of hood bezel to hood (2).
2. Insert bottom of hood bezel (1) to hood (2) ensur-
ing bezel clips fasten.
23 - 130
HOOD
LX
INSTRUMENT PANEL
TABLE OF CONTENTS
page
page
ASH RECEIVER
ASSEMBLY-INSTRUMENT PANEL
BEZEL-CENTER
BEZEL-CLUSTER
BIN-GLOVE BOX
REMOVAL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 152
INSTALLATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 153
COVER-STEERING COLUMN OPENING
GRILLE-DEFROSTER
LATCH-GLOVE BOX
LOCK CYLINDER-GLOVE BOX
SILENCER-INSTRUMENT PANEL
STRIKER-LATCH-GLOVE BOX
LX
INSTRUMENT PANEL
23 - 131
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст