Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 1553
INSTALLATION
1. Position oil cooler to fitting on oil pan.
NOTE: Remove all oil and debris from the seal
retainer surface. The cut out section of the oil
cooler seal retainer flange (top), must be aligned
with the tab on the oil pan. The oil cooler must be
prevented
from
turning
during
the
tightening
sequence.
2. Install oil cooler (1) attaching fastener and tighten
to 61 N·m (45 ft. lbs.).
3. Install oil filter (3) and tighten to 12 N·m (106 in.
lbs.).
4. Connect coolant hoses to oil cooler (2).
5. Fill cooling system (Refer to 7 - COOLING/EN-
GINE/COOLANT - STANDARD PROCEDURE).
9 - 2236
ENGINE - 3.5L - SERVICE INFORMATION
LX
FILTER -OIL
REMOVAL
NOTE: When servicing the oil filter, avoid deform-
ing the filter can. Install the remove/install tool
band strap against the base lock seam. The lock
seam joining the can to the base is reinforced by
the base plate.
1. Using a suitable oil filter wrench, unscrew filter (3)
from base and discard.
INSTALLATION
1. Wipe base clean, then inspect gasket contact sur-
face.
2. Lubricate gasket of new filter (2) with clean engine
oil.
3. Install and tighten filter to 12 N·m (106 in. lbs.) of
torque after gasket contacts base. Use filter wrench
if necessary.
4. Start engine and check for leaks.
LX
ENGINE - 3.5L - SERVICE INFORMATION
9 - 2237
PAN - OIL
REMOVAL
RWD
1. Disconnect negative battery cable.
2. Lock the steering wheel in the center position.
3. Remove engine oil indicator.
4. Raise and support the vehicle.
5. Remove the splash shield.
6. Drain engine oil and remove the oil filter (Refer to 9
- ENGINE/LUBRICATION/OIL - STANDARD PRO-
CEDURE).
7. Remove the oil filter / oil cooler mounting stud and
set oil cooler aside (Refer to 9 - ENGINE/LUBRI-
CATION/OIL COOLER & LINES - REMOVAL).
8. Separate the steering column coupler (1) from the
steering gear (3).
9. Remove steering gear (3) to cradle mounting bolts
and suspend steering gear aside.
10. Remove the flex plate access cover (1).
9 - 2238
ENGINE - 3.5L - SERVICE INFORMATION
LX
11. Remove the rear oil pan (2) to transmission (3)
bolts (1).
12. Remove the two rear oil pan bolts (3).
LX
ENGINE - 3.5L - SERVICE INFORMATION
9 - 2239
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст