Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 1554
13. Remove the remaining oil pan bolts and nuts.
14. Loosen the engine mount bolts at the cradle.
15. Raise and support the engine using a suitable
floor jack with a block of wood at the transmission
housing.
16. Remove the oil pan (1).
NOTE: A small amount of oil will remain in the oil
pan. Use care when removing the oil pan from the
engine.
17. Clean all mating surfaces.
AWD
1. Disconnect the negative battery cable.
2. Drain the cooling system (Refer to 7 - COOLING -
STANDARD PROCEDURE).
3. Remove the oil level indicator tube (2) fastener at
the right exhaust manifold.
9 - 2240
ENGINE - 3.5L - SERVICE INFORMATION
LX
4. Raise and support the vehicle.
5. Remove the splash shield.
6. Drain engine oil and remove the oil filter.
7. Remove the left axle shaft (2).
8. Disconnect the power steering hoses from the
power steering rack.
9. Remove the left front axle intermediate shaft sup-
port bracket and housing (3).
10. Remove the front drive shaft heat shield (4).
11. Paint mark and remove the front drive shaft.
12. Remove the right catalytic converter.
13. Separate the power steering hose from cradle
hold down and position the hose aside.
14. Remove the lower engine mount to cradle fasten-
ers.
15. Remove the front sway bar.
16. Raise and support the engine with a jack stand.
17. Remove the front axle housing support bracket
(1).
18. Remove the front axle housing (3) fasteners,
rotate the housing position and remove the axle
housing (3).
19. Lower the engine and remove the jack stand.
LX
ENGINE - 3.5L - SERVICE INFORMATION
9 - 2241
20. Remove the oil cooler hoses from the oil cooler
and remove the oil cooler (if equipped) (Refer to 9
- ENGINE/LUBRICATION/OIL COOLER & LINES
- REMOVAL).
21. Separate the oil level indicator tube from the oil
pan.
22. Remove the flex plate cover (1).
23. Remove the oil pan (1).
9 - 2242
ENGINE - 3.5L - SERVICE INFORMATION
LX
INSTALLATION
RWD
1. Clean oil pan and all gasket surfaces.
2. Apply a 1/8 inch bead of Mopar
T
Engine RTV GEN
II at the parting line of the oil pump housing and
the rear seal retainer.
3. Install oil pan gasket to the engine block.
4. Install the oil pan while aligning the oil level indica-
tor tube and attach fasteners finger tight.
LX
ENGINE - 3.5L - SERVICE INFORMATION
9 - 2243
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст