Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 521
5. Disconnect the electrical connectors.
6. Separate headlamp unit from vehicle.
REMOVAL - CHARGER
1. On Charger models, the fascia must first be removed to gain access for the removal of headlamp unit and fas-
teners (Refer to 13 - FRAME & BUMPERS/BUMPERS/FRONT FASCIA - REMOVAL).
2. Disconnect and isolate the battery negative cable.
3. Open hood and remove the two upper headlamp
unit mounting screws.
8L - 114
LAMPS/LIGHTING - EXTERIOR - SERVICE INFORMATION
LX
4. The two upper retaining screws (1) are located just
in front of the upper radiator cross-member.
5. Remove the one lower headlamp unit retaining
screw.
6. Disconnect the electrical connectors.
7. Separate headlamp unit from vehicle.
LX
LAMPS/LIGHTING - EXTERIOR - SERVICE INFORMATION
8L - 115
INSTALLATION - 300C AND MAGNUM
1. Position the headlamp unit in the opening in the
headlamp mounting cross-member.
2. Connect the electrical connector.
3. Install the one lower headlamp unit retaining screw.
NOTE: If the fascia was loosened, reattach it
(Refer to 13 - FRAME & BUMPERS/BUMPERS/
FRONT FASCIA - INSTALLATION).
4. Install the two upper retaining screws (1).
5. Connect the battery negative cable.
8L - 116
LAMPS/LIGHTING - EXTERIOR - SERVICE INFORMATION
LX
INSTALLATION - CHARGER
1. Position the headlamp unit in the opening in the
headlamp mounting cross-member.
2. Connect the electrical connector.
3. Install the one lower headlamp unit retaining screw.
4. Install the two upper retaining screws (1).
LX
LAMPS/LIGHTING - EXTERIOR - SERVICE INFORMATION
8L - 117
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст