Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 520
REMOVAL
FRONT
1. Disconnect and isolate the battery negative cable.
2. Hoist vehicle.
3. Unsnap the sensor link from the upper control arm
(front) (1).
4. Disconnect the one electrical connector (4).
5. Remove the two speed nuts (3) to remove sensor
and bracket (2).
REAR
1. Disconnect and isolate the battery negative cable.
2. Hoist vehicle.
3. Unsnap the sensor link from the spring link (rear)
(3).
4. Disconnect the electrical connector (2).
5. Remove the two fasteners to the sensor and
bracket (1).
8L - 110
LAMPS/LIGHTING - EXTERIOR - SERVICE INFORMATION
LX
INSTALLATION
FRONT
1. Install the two retaining nuts (3) to the sensor and
bracket (2).
2. Connect the one electrical connector (4).
3. Snap the sensor link onto the upper control arm
(front) (1).
4. Remove the vehicle from the hoist.
5. Connect the battery negative cable.
6. Using a Scan Tool, calibrate the headlamp leveling
system.
REAR
1. Install the fasteners to the sensor and bracket (1).
2. Connect the electrical connector (2).
3. Snap the sensor link onto the spring link (rear) (3).
4. Remove the vehicle from the hoist.
5. Connect the battery negative cable.
6. Using a Scan Tool, calibrate the headlamp leveling
system.
LX
LAMPS/LIGHTING - EXTERIOR - SERVICE INFORMATION
8L - 111
SWITCH-HEADLAMP
REMOVAL
1. Disconnect and isolate the battery negative cable.
WARNING: Wait two minutes for the airbag system reserve capacitor to discharge before beginning any air-
bag system or component service. Failure to do so may result in accidental airbag deployment, personal
injury or death.
2. Remove steering column opening cover (Refer to
23
-
BODY/INSTRUMENT
PANEL/STEERING
COLUMN OPENING COVER - REMOVAL).
3. From underneath and behind the instrument panel,
push up on the lower clip on headlamp switch then
wiggle it down and out of instrument panel.
4. Disconnect
the
headlamp
switch
electrical
connector.
INSTALLATION
1. Connect the headlamp switch electrical connector.
2. Position headlamp switch in instrument panel and
firmly snap into place.
3. Install the steering column opening cover (Refer to
23
-
BODY/INSTRUMENT
PANEL/STEERING
COLUMN OPENING COVER - INSTALLATION).
8L - 112
LAMPS/LIGHTING - EXTERIOR - SERVICE INFORMATION
LX
HEADLAMP UNIT
REMOVAL - 300C AND MAGNUM
1. Disconnect and isolate the battery negative cable.
2. Open hood and remove the two upper headlamp
unit mounting screws.
3. The two upper retaining screws (1) are located just
in front of the upper radiator cross-member.
NOTE: It may be necessary to loosen the side of
the fascia to access the lower headlamp unit
retaining screw (Refer to 13 - FRAME & BUMPERS/
BUMPERS/FRONT FASCIA - REMOVAL).
4. Remove the one lower headlamp unit retaining
screw.
LX
LAMPS/LIGHTING - EXTERIOR - SERVICE INFORMATION
8L - 113
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст