Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 2150
BEZEL-CLUSTER
REMOVAL
REMOVAL
1. Before proceeding with the following repair proce-
dure, review all warnings and cautions (Refer to 23
- BODY/INSTRUMENT PANEL - WARNING).
2. Using a trim stick C-4755 or equivalent (1), gently
pry between the ignition switch bezel (2) and the
instrument cluster bezel (3) to release the snap
retainers that secure the switch bezel.
3. Remove the ignition switch bezel from the vehicle.
4. Using a trim stick C-4755 or equivalent (1), gently
pry between the instrument panel (2) and the clus-
ter bezel (3) to release the snap clip retainers that
secure the cluster bezel.
23 - 148
INSTRUMENT PANEL
LX
DODGE
1. Before proceeding with the following repair proce-
dure, review all warnings and cautions (Refer to 23
- BODY/INSTRUMENT PANEL - WARNING).
2. Using a trim stick C-4755 or equivalent (1), gently
pry between the ignition switch bezel (2) and the
instrument cluster bezel (3) to release the snap
retainers that secure the switch bezel.
3. Disconnect the wire harness connector from the
headlamp switch (4) and remove the cluster bezel
from the vehicle.
4. Using a trim stick C-4755 or equivalent (1), gently
pry between the cluster bezel (2) and the instru-
ment panel (3) to release the snap clip retainers
that secure the cluster bezel.
5. If required, remove the headlamp switch from the
cluster bezel (Refer to 8 - ELECTRICAL/LAMPS/
LIGHTING - EXTERIOR/HEADLAMP SWITCH -
REMOVAL).
6. Remove the ignition switch bezel from the vehicle.
LX
INSTRUMENT PANEL
23 - 149
INSTALLATION
INSTALLATION
1. Position the cluster bezel (1) onto the instrument
panel (2).
2. Carefully push on the cluster bezel to fully seat the
snap clip retainers into the instrument panel.
3. Position the ignition switch bezel (1) into the cluster
bezel (2).
4. Carefully push on the ignition switch bezel to
engage the snap retainers that secure the switch
bezel.
23 - 150
INSTRUMENT PANEL
LX
INSTALLATION
1. If removed, install the headlamp switch (1) into the
cluster bezel (2) (Refer to 8 - ELECTRICAL/
LAMPS/LIGHTING
-
EXTERIOR/HEADLAMP
SWITCH - INSTALLATION).
2. Position the cluster bezel into the vehicle and con-
nect the wire harness connector to the headlamp
switch.
3. Install the cluster bezel onto the instrument panel
(3) and carefully push on the cluster bezel to fully
seat the snap clip retainers into the instrument
panel.
4. Position the ignition switch bezel (1) into the cluster
bezel (2).
5. Carefully push on the ignition switch bezel to
engage the snap retainers that secure the switch
bezel.
LX
INSTRUMENT PANEL
23 - 151
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст