Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 2151
BIN-GLOVE BOX
REMOVAL
1. Open the glove box bin (1).
2. Push in on both sides of glove box bin to disen-
gage the glove box stops (2) and lower the bin.
3. Pivot the glove box bin downward and disengage
the bin hinge hooks (3) from the instrument panel
hinge brackets (4) located at each end of the bin.
4. Turn the glove box bin (1) sideways and remove
the support strap and retainer assembly (2) from
the outboard end of the bin.
5. Remove the glove box bin from the vehicle.
23 - 152
INSTRUMENT PANEL
LX
INSTALLATION
1. Position the glove box bin (1) into the vehicle.
2. Turn the glove box bin sideways and install the
support strap and retainer assembly (2) onto the
outboard end of the bin.
3. Engage the glove box bin hinge hooks (3) onto the
instrument panel hinge brackets (4) located at each
end of the glove box bin (1) and pivot the bin
upward.
4. To engage the glove box stops (2), push inward on
both sides of the glove box bin and pivot the bin
into the instrument panel.
5. Close the glove box bin.
LX
INSTRUMENT PANEL
23 - 153
COVER-STEERING COLUMN OPENING
REMOVAL
1. Disconnect and isolate negative battery cable.
2. Remove the screws (2 and 6) that secure the steering column cover (1) to the instrument panel.
3. Pull the steering column cover rearward at the top and right side of the cover to release the snap retainers from
the instrument panel.
4. Disconnect the wire harness connector (3) from the trunk release switch, if equipped.
5. Disconnect the release cable (4) from the emergency bracket release handle (5) and remove the steering column
cover from the vehicle.
6. If required, remove the screws (3) that secure the
instrument panel steering column cover reinforce-
ment (1) to the bracket (2) and remove the rein-
forcement from the vehicle.
23 - 154
INSTRUMENT PANEL
LX
INSTALLATION
1. If removed, position the instrument panel steering
column cover reinforcement (1) onto the bracket
(2).
2. Install the screws (3) that secure the instrument
panel steering column cover reinforcement to the
bracket. Tighten the screws securely.
3. Position the steering column cover (1) into the vehicle.
4. Connect the release cable (4) to the emergency brake release handle (5).
5. Connect the wire harness connector (3) to the trunk release switch, if equipped.
6. Install the steering column cover onto the instrument panel and carefully push on the top and right side of the
cover to fully seat the snap clip retainers into the instrument panel.
7. Install the screws (2 and 6) that secure the steering column cover (1) to the instrument panel. Tighten the screws
securely.
LX
INSTRUMENT PANEL
23 - 155
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст