Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 1611
INSTALLATION - ENGINE
1. Install engine lift fixture (2) Special tool # 8984 and
8984–UPD (4).
2. Position the engine in the engine compartment.
3. Lower engine into compartment and align engine
with transmission.
4. Mate engine and transmission and install two trans-
mission to engine block mounting bolts finger tight.
5. Lower engine assembly until engine mount studs
rest in frame perches.
6. Install remaining transmission to engine block
mounting bolts (1, 2)and tighten.
7. Install and tighten engine mount to frame nuts.
9 - 2468
ENGINE - 6.1L SERVICE INFORMATION
LX
8. Install drive plate to torque converter bolts (1).
9. Install the torque convertor access cover (1).
LX
ENGINE - 6.1L SERVICE INFORMATION
9 - 2469
10. Install the starter (1) and heat shield (4) and con-
nect the starter wires (Refer to 8 - ELECTRICAL/
STARTING/STARTER MOTOR - INSTALLATION).
11. Install exhaust pipe to manifold.
12. Lower the vehicle.
13. Remove engine lift fixture (2), special tool # 8984
and 8984–UPD (4).
14. Connect the fuel supply line (Refer to 14 - FUEL
SYSTEM/FUEL
DELIVERY/QUICK
CONNECT
FITTING - STANDARD PROCEDURE).
15. Reinstall the power steering pump.
9 - 2470
ENGINE - 6.1L SERVICE INFORMATION
LX
16. Connect the heater hoses(1, 1,).
17. Reconnect the ground wires to the rear of each
cylinder head.
18. Install the intake manifold. (Refer to 9 - ENGINE/
MANIFOLDS/INTAKE
MANIFOLD
-
INSTALLATION).
LX
ENGINE - 6.1L SERVICE INFORMATION
9 - 2471
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст