Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 271
B1461-CHANNEL 1 AUDIO SPEAKER OUTPUT CIRCUIT LOW
For a complete wiring diagram Refer to Section 8W.
8A - 10
AUDIO - ELECTRICAL DIAGNOSTICS
LX
•
When Monitored:
•
With the ignition on.
•
Set Condition:
•
The Amplifier detects a shorted to ground condition on the speaker output circuit.
Possible Causes
(X209) AMPLIFIED LEFT FRONT I/P SPEAKER (+) CIRCUIT SHORTED TO GROUND
(X299) AMPLIFIED LEFT FRONT I/P SPEAKER (-) CIRCUIT SHORTED TO GROUND
LEFT FRONT I/P SPEAKER
AMPLIFIER
Diagnostic Test
1.
CHECK FOR AN INTERMITTENT CONDITION
Turn the ignition on, then off, and then on again.
With the scan tool, read Amplifier DTCs.
Does the scan tool display active: B1461-CHANNEL 1 AUDIO SPEAKER OUTPUT CIRCUIT LOW?
Yes
>> Go To 2
No
>> The conditions that caused this code to set are not present at this time. Using the wiring diagram/sche-
matic as a guide, inspect the wiring and connectors.
Perform BODY VERIFICATION TEST VER-1.
2.
CHECK THE (X209) AMPLIFIED LEFT FRONT I/P SPEAKER (+) CIRCUIT FOR A SHORT TO GROUND
Disconnect the Amplifier C2 harness connector.
Measure the resistance between ground and the (X209) Amplified Left
Front I/P Speaker (+) circuit.
Is the resistance below 10K ohms?
Yes
>> Repair the (X209) Amplified Left Front I/P Speaker (+) cir-
cuit for a short to ground.
Perform BODY VERIFICATION TEST VER-1.
No
>> Go To 3
LX
AUDIO - ELECTRICAL DIAGNOSTICS
8A - 11
3.
CHECK THE (X299) AMPLIFIED LEFT FRONT I/P SPEAKER (-) CIRCUIT FOR A SHORT TO GROUND
Measure the resistance between ground and the (X299) Amplified Left
Front I/P Speaker (-) circuit.
Is the resistance below 10K ohms?
Yes
>> Repair the (X299) Amplified Left Front I/P Speaker (-) for a
short to ground.
Perform BODY VERIFICATION TEST VER-1.
No
>> Go To 4
4.
CHECK OPERATION OF THE AMPLIFIED LEFT FRONT I/P SPEAKER
Turn the ignition off.
Reconnect and reinstall the Left Front I/P Speaker.
Measure the resistance of the speaker circuit between the Amplifier C2
harness connector and ground.
Is the resistance below 10K ohms?
Yes
>> Replace the Left Front I/P Speaker in accordance with the
service information.
Perform BODY VERIFICATION TEST VER-1.
No
>> Replace the Amplifier in accordance with the service infor-
mation.
Perform BODY VERIFICATION TEST VER-1.
8A - 12
AUDIO - ELECTRICAL DIAGNOSTICS
LX
B1462-CHANNEL 1 AUDIO SPEAKER OUTPUT CIRCUIT HIGH
For a complete wiring diagram Refer to Section 8W.
LX
AUDIO - ELECTRICAL DIAGNOSTICS
8A - 13
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст