Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 73
16. Disengage right halfshaft (1) from axle and
remove from vehicle.
17. Remove left halfshaft (1) from vehicle.
INTERMEDIATE SHAFT ASSEMBLY
NOTE: The intermediate shaft assembly is serviced only as an assembly.
Right Halfshaft Removal/Installation
3 - 24
SHAFT-HALF (FRONT)
LX
1. Remove four (4) intermediate shaft assembly-to-oil
pan bolts.
2. Remove intermediate shaft assembly (2) from
engine oil pan.
INSTALLATION
1. If previously removed, install intermediate shaft
assembly (2). Install four intermediate shaft-to-oil
pan bolts and torque to 25 N·m (18 ft. lbs.).
2. Install left halfshaft assembly (1).
LX
SHAFT-HALF (FRONT)
3 - 25
3. Using Tool C-4193-A (1), install new axle seal.
4. Install right halfshaft assembly (1).
5. Install halfshaft (1) into hub/bearing assembly (2).
Right Halfshaft Removal/Installation
3 - 26
SHAFT-HALF (FRONT)
LX
6. Loosely install halfshaft hub nut (1), and do not
tighten at this time.
CAUTION:
It
is
important
to
tighten
nut
as
described in following step to avoid damaging ball
stud joint.
7. Place upper ball joint stud (1) through hole in top of
knuckle and install nut (4). Tighten nut by holding
ball joint stud with a hex wrench while turning nut
with a wrench. Tighten nut using crow foot wrench
on torque wrench to 47 N·m + 90° turn (35 ft. lbs. +
90° turn) torque.
NOTE: Inspect brake shoes (pads) before installation. (Refer to 5 - BRAKES/HYDRAULIC/MECHANICAL/
BRAKE PADS/SHOES - INSPECTION)
LX
SHAFT-HALF (FRONT)
3 - 27
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст