Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 1528
REMOVAL - CYLINDER HEAD(S)
RIGHT CYLINDER HEAD
1. Perform the fuel relief procedure.
2. Disconnect the negative battery cable.
3. Drain cooling system (Refer to 7 - COOLING -
STANDARD PROCEDURE).
4. Remove the upper intake manifold (Refer to 9 -
ENGINE/MANIFOLDS/INTAKE
MANIFOLD
-
REMOVAL).
5. Remove the lower intake manifold (Refer to 9 -
ENGINE/MANIFOLDS/INTAKE
MANIFOLD
-
REMOVAL).
6. Remove accessory drive belt (6).
7. Remove accessory drive belt idler pulley.
8. Remove the power steering mounting bolts and set
the pump aside (Refer to 19 - STEERING/PUMP -
REMOVAL).
9. Raise the vehicle.
10. Remove crankshaft damper (4) (Refer to 9 -
ENGINE/ENGINE BLOCK/VIBRATION DAMPER -
REMOVAL.
11. Remove lower outer timing belt cover bolts.
12. Remove front exhaust pipe to exhaust manifold
mounting nuts (1).
13. Disconnect both oxygen sensor (2) harness con-
nectors on each side.
14. Lower vehicle.
15. Remove the remaining outer timing belt cover
bolts and cover.
9 - 2136
ENGINE - 3.5L - SERVICE INFORMATION
LX
16. Rotate the engine to TDC and align timing belt marks (1,8,9).
17. Remove the timing belt tensioner (12) and reset the tensioner (Refer to 9 - ENGINE/VALVE TIMING/TMNG
BELT/CHAIN TENSIONER&PULLEY - REMOVAL).
18. Remove the timing belt (4) (Refer to 9 - ENGINE/VALVE TIMING/TIMING BELT/CHAIN AND SPROCKETS -
REMOVAL).
TIMING GEAR ALIGNMENT
1 - RIGHT CAMSHAFT GEAR ALIGNMENT MARK
7 - LEFT CAMSHAFT GEAR
2 - RIGHT CAMSHAFT GEAR
8 - LEFT CAMSHAFT GEAR ALIGNMENT MARK
3 - CYLINDER HEAD TO INNER TIMING BELT COVER BOLTS -
RIGHT
9 - CRANKSHAFT GEAR ALIGNMENT MARK
4 - TIMING BELT
10 - CRANKSHAFT GEAR
5 - WATER PUMP PULLEY
11 - TIMING BELT TENSIONER PULLEY
6 - CYLINDER HEAD TO INNER TIMING BELT COVER BOLTS -
LEFT
12 - TIMING BELT TENSIONER
LX
ENGINE - 3.5L - SERVICE INFORMATION
9 - 2137
19. Remove the right cylinder head cover to cylinder
head ground strap and capacitor (3).
20. Remove the EGR valve and tube assembly.
21. Remove the right cylinder head cover.
22. Remove the right rocker arm assembly (2).
9 - 2138
ENGINE - 3.5L - SERVICE INFORMATION
LX
23. Remove the right rear camshaft thrust plate (1).
24. Counterhold the cam gear and remove the right
cam gear retaining bolt.
LX
ENGINE - 3.5L - SERVICE INFORMATION
9 - 2139
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст