Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 1837
9. Remove the telescoping lever from the SCCM.
INSTALLATION
1. Install the telescoping lever to the SCCM.
19 - 166
COLUMN SERVICE INFORMATION
LX
2. Install the screws (4) fastening the telescoping
steering lever to the SCCM (5).
3. If equipped with ESP, install the steering angle
sensor (1) to the SCCM (2).
4. Install the clockspring screws (1). (Refer to 8 -
ELECTRICAL/RESTRAINTS/CLOCKSPRING
-
REMOVAL).
LX
COLUMN SERVICE INFORMATION
19 - 167
5. Align the spline on the steering wheel hub to shaft.
6. Then install the steering wheel (1) and install a
NEW retainer bolt (2). Tighten the bolt to 70 N·m
(52 ft. lbs.).
7. Install the airbag (3). (Refer to 8 - ELECTRICAL/
RESTRAINTS/DRIVER AIRBAG - REMOVAL)
8. Install the negative battery terminal on the battery.
It is important that this is performed properly
(including calibration of steering angle sensor if
equipped with ESP). (Refer to 8 - ELECTRICAL/
BATTERY SYSTEM - STANDARD PROCEDURE)
9. Test the operation of the horn, lights and any other
functions that are steering column operated.
19 - 168
COLUMN SERVICE INFORMATION
LX
LEVER-GEAR SHIFT
REMOVAL
WARNING: Before servicing the steering column the airbag system must be disarmed. Refer to electrical
restraint system for service procedures. Failure to do so may result in accidental deployment of the airbag
and possible personal injury.
1. Disconnect the negative (ground) cable from the battery.
2. Remove the steering column opening cover (1) (Refer to 23 - BODY/INSTRUMENT PANEL/STEERING COL-
UMN OPENING COVER - REMOVAL).
3. Remove the steering column opening reinforce-
ment (1).
LX
COLUMN SERVICE INFORMATION
19 - 169
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст