Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 130
1. With vehicle in neutral, position and raise vehicle
on hoist.
2. Using 14mm hex, remove axle drain plug (1) and
drain rear axle fluid into container suitable for fluid
reuse.
3. Install drain plug (1) and torque to 50 N·m (37 ft.
lbs.) torque.
4. Remove rear exhaust system (2) on dual-outlet
exhaust models, otherwise, lower exhaust system
at rear hanger(s).
5. Apply alignment index marks (3) to the propeller
shaft rubber coupler (1) and axle flange (2).
3 - 252
REAR AXLE - 215RII
LX
6. Remove three (3) propeller shaft coupler-to-axle
flange bolt/nuts.
7. Using suitable screwdriver (1), partially disengage
halfshaft(s) (2) from axle assembly.
8. If a drive-on hoist is used, position transmission
jack(1) to rear axle assembly. If a drive-on hoist is
not used, compress rear suspension using screw-
style under-hoist jack stands (2), then position
transmission jack to rear axle assembly.
LX
REAR AXLE - 215RII
3 - 253
9. Remove rear axle forward mount isolator (1) bolt/
nut (2).
10. Remove two rear axle-to-crossmember bolts (1).
11. Carefully lower rear axle. While lowering axle,
separate propeller shaft from axle and support
with suitable rope or wire (1).
3 - 254
REAR AXLE - 215RII
LX
12. Lower axle just enough to remove both halfshafts
one at a time. Shift axle assembly in one direc-
tion, compressing one halfshaft while removing
the other (1). Use caution to protect axle seal and
journal.
13. Remove axle assembly from vehicle and transfer
to bench.
14. Using suitable screwdriver, remove axle seals and
discard.
LX
REAR AXLE - 215RII
3 - 255
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст