Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 128
14. Rotate pinion flange to ensure bearing is properly
seated.
15. Measure pinion rotating torque using suitable
torque
wrench
(1).
Pinion
rotating
torque
should be 215-245 N. cm (19-22 in. lbs.).
16. If pinion rotating torque exceeds the specified
range, the pinion shaft must be removed and the
crush sleeve replaced.
17. If pinion rotating torque is below the specified
range, increase nut torque by 7 N·m (5 ft. lbs.)
increments and recheck turning torque until rotat-
ing torque is within range.
18. Stake pinion flange nut (1) using hammer and
suitable punch.
3 - 244
REAR AXLE - 210RII
LX
19. Install ring gear to differential case. Loosely install
new ring-gear-to-differential case bolts.
20. Torque all ring gear-to-case bolts to 85 N·m (64 ft.
lbs.)
21. Install differential and reassemble axle assembly.
(Refer to 3 - DIFFERENTIAL & DRIVELINE/REAR
AXLE - 210MM/DIFFERENTIAL - INSTALLATION)
LX
REAR AXLE - 210RII
3 - 245
REAR AXLE - 215RII
TABLE OF CONTENTS
page
page
REAR AXLE - 215RII
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 251
SPECIAL TOOLS–215 MM RII AXLE . . . . . . . . . . . 260
SEAL - PINION FLANGE
SEAL - AXLE SHAFT
3 - 246
REAR AXLE - 215RII
LX
REAR AXLE - 215RII
DESCRIPTION
The 215 MM RII (Rear-Independent-Iron) axle is an independent assembly with a cast iron housing and differential.
The 215 MM RII uses an open differential which is supported by two tapered roller bearings located on either side
of the case. Differential bearing preload and ring gear backlash are controlled with select snap-rings located on the
outside of the differential bearing cups. Pinion height is set with a select shim located under the rear pinion bearing
cup.
AXLE IDENTIFICATION
The 215 MM axle utilizes a barcoded label which is adhered to the top of the axle housing as shown. The following
information is found on the identification label:
•
Traceability Code (Plant Use)
•
Axle Part Number
•
Axle Gear Ratio
LX
REAR AXLE - 215RII
3 - 247
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст