Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 571
(Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - DIAGNOSIS AND TESTING) for the diagnostic
test procedure.
U0209-LOST COMMUNICATION WITH MEMORY SEAT CONTROL MODULE
For a complete wiring diagram Refer to Section 8W.
(Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - DIAGNOSIS AND TESTING) for the diagnostic
test procedure.
U0212-LOST COMMUNICATION WITH SCCM-CAN-B
For a complete wiring diagram Refer to Section 8W.
(Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - DIAGNOSIS AND TESTING) for the diagnostic
test procedure.
U0231-LOST COMMUNICATION WITH RAIN SENSING MODULE
For a complete wiring diagram Refer to Section 8W.
(Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - DIAGNOSIS AND TESTING) for the diagnostic
test procedure.
U0241-LOST COMMUNICATION WITH AUTO HIGHBEAM HEADLAMP CONTROL
MODULE
For a complete wiring diagram Refer to Section 8W.
(Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - DIAGNOSIS AND TESTING) for the diagnostic
test procedure.
8M - 154
OVERHEAD CONSOLE - ELECTRICAL DIAGNOSTICS
LX
OVERHEAD CONSOLE - SERVICE INFORMATION
TABLE OF CONTENTS
page
page
OVERHEAD CONSOLE - SERVICE
ELECTRONIC VEHICLE INFORMATION
ELECTRONIC VEHICLE INFORMATION
CENTER . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 161
UNIVERSAL TRANSMITTER
DESCRIPTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 166
UNIVERSAL TRANSMITTER . . . . . . . . . . . . . . . . 166
SENSOR-AMBIENT AIR TEMPERATURE
AMBIENT TEMPERATURE SENSOR . . . . . . . . . 170
LX
OVERHEAD CONSOLE - SERVICE INFORMATION
8M - 155
OVERHEAD CONSOLE - SERVICE INFORMATION
DESCRIPTION
An overhead console is standard on this vehicle and
includes the following components:
•
Overhead storage compartment (1)
•
Front map/reading lamps (2)
•
Power sunroof switch (3) - if equipped
•
Universal transmitter (4)
•
Electronic Overhead Module
The overhead console assembly is mounted by three
snap clips (1) securing it to a molded plastic retainer
bracket located above the headliner. The Electronic
Overhead Module is secured to the overhead console
with screws (2).
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Pull downward on the sides of the overhead con-
sole housing firmly and evenly to disengage the
snap clips from the overhead console bracket.
8M - 156
OVERHEAD CONSOLE - SERVICE INFORMATION
LX
3. Lower the overhead console from the headliner far
enough to access the wire harness connectors (2).
4. Disconnect the roof wire harness connectors (2)
from the overhead console wire harness connector.
5. Remove the overhead console from the headliner.
INSTALLATION
1. Position the overhead console near the mounting
location on the headliner.
2. Reconnect the roof wire harness connectors (2) to
the overhead console.
3. Align the snap clips on the overhead console hous-
ing with their receptacles (1) in the overhead con-
sole bracket.
4. Push upward firmly and evenly on the sides of the
overhead console housing over the snap clip loca-
tions until the snap clip is fully engaged with its
receptacle in the overhead console bracket.
5. Reconnect the battery negative cable.
LX
OVERHEAD CONSOLE - SERVICE INFORMATION
8M - 157
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст