Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 2132
11. Use a wrench inserted through the access slot on
the outer latch face of the rear door shell to
loosen the hex socket latch release adjusting
screw (2) on the latch (1).
12. Cycle the door outside latch release handle
through its full travel two or three times.
13. Tighten the adjusting screw.
23 - 76
DOOR - REAR
LX
STRIKER
REMOVAL
1. Open the rear door.
2. Mark the rear door latch striker (3) location on the
face of the outer C-pillar (1) to aid reinstallation.
3. Remove the two screws (2) that secure the striker
to the C-pillar.
4. Remove the striker from the C-pillar.
INSTALLATION
1. Position the rear door latch striker (3) on the face
of the outer C-pillar (1).
2. Install and tighten the two screws (2) that secure
the striker to the C-pillar. Tighten the screws to 33
N·m (24 ft. lbs.).
3. Adjust the latch striker position as necessary to
achieve proper door spacing and latch operation.
LX
DOOR - REAR
23 - 77
TRIM PANEL
REMOVAL
1. Disconnect and isolate the battery negative cable.
(Refer to 8 - ELECTRICAL/BATTERY SYSTEM -
STANDARD PROCEDURE).
2. Unsnap and fold back the screw cap below the trim
panel pull cup to access and remove the screw (5)
that secures the panel (2) to the pull cup bracket.
3. Unsnap and fold back the screw cap within the
interior remote handle recess of the trim panel to
access and remove the screw (4) that secures the
panel to the inside of the door (1).
4. Remove the four screws (6) that secure the bottom
and front lower corner of the trim panel to the
inside of the door.
5. Remove the three push-pin retainers (1) that
secure the trim panel to the inside of the door.
(Refer to 23 - BODY/DOOR - FRONT - DESCRIP-
TION - FASTENERS).
23 - 78
DOOR - REAR
LX
6. Pull the trim panel (2) away from the inside of the
door far enough to disengage the locator pins near
the top of the panel from the door and the steel clip
fastener. Then lift the rear of the panel upward far
enough to disengage the interior door latch lock
link and knob (1) from the clearance hole at the
upper rear corner of the panel.
7. Reach between the top of the trim panel (3) and
the inside of the door shell to unsnap the plastic
clip that secures the end of the interior door handle
latch release link (1) to the handle lever (2) and
disengage the link from the handle.
8. Pull the trim panel away from the inside of the door
shell far enough to access and disconnect the door
wire harness connector (5) from the power window
switch (4).
9. Remove the trim panel from the inside of the door.
NOTE: A battery reconnect procedure must be performed anytime the battery has been disconnected. (Refer
to 8 - ELECTRICAL/BATTERY SYSTEM - STANDARD PROCEDURE).
LX
DOOR - REAR
23 - 79
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст