Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 2154
STRIKER-LATCH-GLOVE BOX
REMOVAL
1. Open the glove box door (1).
2. Remove the two screws (2) that secure the glove
box latch striker (3) to the instrument panel (4).
3. Remove the glove box latch striker from the instru-
ment panel.
INSTALLATION
1. Position the glove box latch striker (3) onto the
instrument panel (4).
2. Install the two screws (2) that secure the glove box
latch striker onto the instrument panel. Tighten the
screws securely.
3. Close glove box door (1).
23 - 164
INSTRUMENT PANEL
LX
INTERIOR
TABLE OF CONTENTS
page
page
A-PILLAR TRIM
B-PILLAR TRIM
C-PILLAR TRIM
CARPET
CONSOLE-FLOOR
COWL TRIM
D-PILLAR TRIM
REMOVAL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 185
INSTALLATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 185
FRONT FLOOR FOOT REST
HEADLINER
LIFTGATE OPENING UPPER TRIM
LIFTGATE SCUFF PLATE
QUARTER TRIM PANEL
QUARTER TRIM SPEAKER BEZEL
REAR DOOR SILL SCUFF PLATE
REAR SHELF TRIM PANEL
MIRROR-INSIDE REARVIEW
REMOVAL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 200
INSTALLATION
TRUNK LINING
TRUNK REAR TRIM PANEL
LX
INTERIOR
23 - 165
A-PILLAR TRIM
REMOVAL
1. Using a trim stick or another suitable wide flat-
bladed tool, carefully pry the upper end of the A-pil-
lar trim (1) rearward from the inside of the A-pillar
(3) far enough to disengage the two spring clip
retainers that secure the trim to the slots in the pil-
lar.
2. Disengage the base of the A-pillar trim from the
end of the instrument panel top cover.
3. Remove the A-pillar trim from the vehicle.
INSTALLATION
1. Check to be certain that the energy absorbing car-
tridge (1) is properly installed and in good condition
on the inside of the A-pillar (2). Replace the car-
tridge if any damage is evident. Tighten the screws
(3) to 3 N·m (25 in. lbs.).
23 - 166
INTERIOR
LX
2. Check to be certain that the grommet (2) for the
front tether of the side curtain airbag is properly
installed and in good condition. Replace the grom-
met if any damage is evident. (Refer to 8 - ELEC-
TRICAL/RESTRAINTS/CURTAIN
AIRBAG
-
REMOVAL).
3. Engage the base of the A-pillar trim (1) to the end
of the instrument panel top cover.
4. Align the two spring clip retainers on the trim with
the slots in the inner A-pillar (3).
5. Using hand pressure, press firmly and evenly for-
ward on the trim over each of the spring clip loca-
tions until the retainers snap into place.
LX
INTERIOR
23 - 167
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст