Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 428
2. Work starter up and pass the intermediate shafts.
3. Starter pass the intermediate shaft.
4. Angle starter up toward engine.
8F - 98
STARTING
LX
5. Install plastic retainer into starter dust shield. The
dust shield has TOP marked on it and the plastic
retainer goes in the hole.
6. Plastic retainer installed.
7. Install dust shield to the engine block using the
plastic retainer to hold dust shield in place.
8. Install starter.
9. Install starter bolts.
10. Tighten bolts to 54.2 N·m (40 ft. lbs.).
LX
STARTING
8F - 99
11. Install electrical connection to starter.
12. Match flats inside intermediate shaft with that in
intermediate shaft extension, then slide intermedi-
ate shaft onto extension.
13. Aline the hole in the shafts.
8F - 100
STARTING
LX
14. Install pinch bolt fastening intermediate shaft to
intermediate shaft extension.
15. Tighten pinch bolt to 43 N·m (32 ft. lbs.).
16. Install the underbody splash shield.
17. Lower vehicle.
18. Remove the steering wheel holder.
19. Connect negative battery cable.
INSTALLATION - 6.1L
REAR WHEEL DRIVE (RWD)
1. Position starter (2) into transmission but do not
install bolts.
2. Connect solenoid wire to starter motor (snaps on).
3. Position battery cable to solenoid stud. Install and
tighten battery cable eyelet nut. Refer to Torque
Specifications. Do not allow starter motor to hang
from wire harness.
4. Install and tighten three mounting bolts (1). Refer
to Torque Specifications.
LX
STARTING
8F - 101
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст