Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 1720
25. Remove bungee cord (1) supporting propeller
shaft (2).
26. Align propeller shaft index marks (3) placed upon
removal. Install propeller shaft rear coupler-to-axle
flange bolts and nuts by hand. Tighten propeller
shaft rear coupler-to-axle flange bolts to 81 N·m
(60 ft. lbs.).
27. Install fuel filler tube. (Refer to 14 - FUEL SYS-
TEM/FUEL DELIVERY/FUEL TANK FILLER TUBE
- INSTALLATION)
13 - 80
FRAME & BUMPERS
LX
28. Clip left rear wheel speed sensor cable (3) to
routing clip (1) near body connector.
29. Match left rear wheel speed sensor connector (4)
to right sensor connector (3) to make one connec-
tor.
30. Insert speed sensor connectors (3 and 4) into
body wiring harness connector (1) located in lug-
gage compartment floor pan (2). When installing
connector, make sure retaining clip on body con-
nector is properly in place and sensor connector
cannot be pulled out.
31. If equipped with standard or premium disc brakes,
on each rear disc brake:
a. Push caliper guide pins into caliper adapter to
clear caliper mounting bosses when installing.
b. Guide caliper and brake hose down through
rear suspension, then slide caliper over brake
pads and onto caliper adapter (3).
c.
CAUTION: Extreme caution should be taken not to
cross-thread caliper guide pin bolts (2) when they
are installed.Align caliper mounting holes with
guide pins, then install guide pin bolts (2). While
holding guide pins from turning, tighten bolts to
31 N·m (23 ft. lbs.) torque.
d. Make sure brake hose is properly routed and
will not come in contact with suspension
components.
LX
FRAME & BUMPERS
13 - 81
32. If equipped with SRT8 disc brakes, at each rear disc brake, support spring link using a transmission jack or
other appropriate jack as indicated in removal procedure. (Refer to 13 - FRAME & BUMPERS/FRAME/BUSH-
ING - REMOVAL)
33. If equipped with SRT8 disc brakes, on each rear
disc brake, slide caliper with pads (2) over brake
rotor and align with knuckle.
34. If equipped with SRT8 disc brakes, on each rear
disc brake, install caliper mounting bolts (1).
Tighten bolts to 130 N·m (96 ft. lbs.) torque.
35. If equipped with SRT8 disc brakes, on each rear
disc brake, remove jack from under spring link.
36. Route parking brake cable above rear crossmem-
ber, then slide cable (1, 3) through equalizer (2)
above rear axle differential (once installed).
13 - 82
FRAME & BUMPERS
LX
NOTE: Due to short travel and low spring tension,
it is not necessary to lock-out parking brake lever
to service parking brake components.
37. Connect front parking brake cable (5) at connec-
tor (3) to right rear parking brake cable (4).
38. Insert front parking brake cable routing bracket
locating pin into front flange of crossmember (3),
then install screw (2) fastening cable (1) routing
bracket to rear crossmember.
39. Install
rear
exhaust
system
(2)
(dual-outlet
exhaust shown in figure). (Refer to 11 - EXHAUST
SYSTEM - INSTALLATION)
LX
FRAME & BUMPERS
13 - 83
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст