Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 2135
7. Remove the tape securing the door glass in its full
up position, then lower the glass to engage it into
the two window regulator glass clamps (2).
8. Using the regulator, lower the glass far enough to
access the two window regulator glass clamp
screws (3).
9. Tighten the screw in each of the glass clamps.
Tighten the screws to 10 N·m (90 in. lbs.).
10. With the upper screw hand-started into the pull
cup bracket (1), position the screw into the keyed
hole on the inside of the rear door.
11. Install and tighten the screw (2) that secures the
bottom of the pull cup bracket to the U-nut (3) on
the inside of the rear door. Tighten the screw to 11
N·m (100 in. lbs.).
12. Tighten the screw that secures the top of the pull
cup bracket to the inside of the rear door. Tighten
the screw to 10 N·m (90 in. lbs.).
13. Reinstall the glass channel and bracket onto the
inside of the rear door. (Refer to 23 - BODY/
DOORS
-
REAR/GLASS
RUN
CHANNEL
-
INSTALLATION).
14. Reinstall the watershield onto the inside of the
rear door. (Refer to 23 - BODY/DOOR - REAR/
WATERSHIELD - INSTALLATION).
15. Reinstall the inner belt weatherstrip onto the rear
door. (Refer to 23 - BODY/WEATHERSTRIP/
SEALS/DOOR INNER BELT WEATHERSTRIP - INSTALLATION-REAR).
16. Reinstall the trim panel onto the inside of the rear door. (Refer to 23 - BODY/DOOR - REAR/TRIM PANEL -
INSTALLATION).
23 - 88
DOOR - REAR
LX
CABLE - REMOTE LOCK ACTUATOR
REMOVAL
1. Disconnect battery.
2. Open the front door.
3. Remove the lock actuator knob lock nut.
4. Open rear door.
5. Remove the trim panel and watershield. (Refer to
23
-
BODY/DOORS
-
REAR/TRIM
PANEL -
REMOVAL)
LX
DOOR - REAR
23 - 89
6. Cut zip ties connecting actuator cable to door rein-
forcement.
7. Drill out rivets (2).
8. Remove door lock actuator cable from door.
INSTALLATION
1. Install the cable into the door and through the hole
in the door shut face.
2. Install and tighten the cable nut.
23 - 90
DOOR - REAR
LX
3. Replace zip ties and fasten to door replacement
bar.
4. Rivet actuator cable bracket to door..
5. Reinstall the watershield and the trim panel. (Refer
to 23 - BODY/DOORS - REAR/TRIM PANEL -
INSTALLATION)
LX
DOOR - REAR
23 - 91
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст