Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 2188
DEFLECTOR-WIND
REMOVAL
1. Open the sunroof fully.
2. Remove the strap screws (2) from the beam area
release the strap (3).
3. Rotate the deflector up and remove springs (2)
from the holes in the frame (1).
23 - 300
SUNROOF - SERVICE INFORMATION
LX
INSTALLATION
1. Position the deflector spring arms (2) into the holes
of the frame (1).
2. Rotate the deflector down, attach the straps (3)
and install the strap screws (2) into the front beam.
3. Verify sunroof operation and alignment.
LX
SUNROOF - SERVICE INFORMATION
23 - 301
GLASS
REMOVAL
1. Move the glass panel (2) to the full closed position.
2. Slide sunshade rearward to the open position.
3. Separate the mechanism covers (2) from the tabs
(1) on the glass panel.
4. Remove the glass panel screws (2).
5. Lift off glass panel and remove from vehicle.
23 - 302
SUNROOF - SERVICE INFORMATION
LX
INSTALLATION
CAUTION: Charger sunglass seal is serviceable. 300 / Magnum seal is not serviceable.
Position glass panel on to mechanism lift arms.
CAUTION: Verify that the retaining tabs are located on the INSIDE of the guide mechanism arms.
1. Start the attaching screws (2).
2. Connect a 12v power supply and verify that the sunroof is in the closed position.
3. Adjust sunroof glass to fit flush with roof line (Refer to 23 - BODY/SUNROOF/GLASS PANEL - ADJUSTMENTS).
4. Tighten the screws to 5.5 N·m (49 in. lbs.).
5. Position the mechanism covers (2) over the glass
tabs (1) between the locating features and seat
fully.
6. Verify sunroof operation and alignment.
LX
SUNROOF - SERVICE INFORMATION
23 - 303
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст