Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 246
2. Remove three screws (2) attaching ABM (1).
3. Remove ABM (1) from HCU (3).
5 - 426
BRAKES - ABS SERVICE INFORMATION
LX
ASSEMBLY
1. Align ABM solenoids and pump/motor wiring con-
nector (4) with HCU valves (2) and connector pas-
sage. Slide ABM (1) onto HCU (3).
2. Install three screws (2) attaching ABM (1). Tighten
screws to 2 N·m (17 in. lbs.) torque.
3. Attach mounting bracket to HCU. Install two mount-
ing bracket attaching screws and tighten to 11 N·m
(97 in. lbs.) torque.
4. Install ICU in vehicle. (Refer to 5 - BRAKES/HY-
DRAULIC/MECHANICAL/ICU (INTEGRATED CON-
TROL UNIT) - INSTALLATION)
LX
BRAKES - ABS SERVICE INFORMATION
5 - 427
INSTALLATION
1. Install unit (5), pushing mounting bracket down into
mounting grommets (8) located in body of vehicle.
2. Connect 47-way wiring connector (5) at antilock
brake module (ABM) (6).
3. Install brake tubes to rear (1 and 3) at hydraulic
control unit. Tighten tube nuts to 20 N·m (177 in.
lbs.) torque.
5 - 428
BRAKES - ABS SERVICE INFORMATION
LX
4.
Install brake tubes (1, 2, 3 and 10) at hydraulic
control unit (5). Tighten tube nuts to 20 N·m (177
in. lbs.) torque.
5. Remove brake pedal holding tool.
6. Connect battery negative cable (2) to battery post.
It is important that this is performed properly. (Refer
to 8 - ELECTRICAL/BATTERY SYSTEM - STAN-
DARD PROCEDURE)
7. Fill and bleed (1) base brake hydraulic system and
ABS. (Refer to 5 - BRAKES - STANDARD PROCE-
DURE)
8. Perform Verification Test and clear any faults.
(Refer
to
5
-
BRAKES
-
DIAGNOSIS AND
TESTING)
LX
BRAKES - ABS SERVICE INFORMATION
5 - 429
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст