Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 1556
22. Install the left front drive axle intermediate shaft
housing (3) and support bracket. Tighten fasten-
ers to 25 N·m (19 lbs. ft.).
23. Connect the power steering hoses to the steering
rack.
24. Install the left front drive axle (2).
25. Install the right front drive axle (2).
26. Lower the vehicle.
27. Fill engine crankcase with the proper oil to the correct level (Refer to LUBRICATION & MAINTENANCE/FLUID
TYPES - SPECIFICATIONS).
28. Fill the cooling system (Refer to 7 - COOLING - STANDARD PROCEDURE).
29. Fill the power steering.
30. Connect the negative battery cable.
9 - 2248
ENGINE - 3.5L - SERVICE INFORMATION
LX
SWITCH-OIL PRESSURE SENSOR
REMOVAL
1. Raise vehicle on hoist.
2. Position an oil collecting container under switch
location.
3. Disconnect electrical connector.
4. Unscrew oil pressure switch (1).
INSTALLATION
1. Apply Mopar
T
Thread Sealant to the switch (1)
threads.
2. Install oil pressure switch (1) to fitting.
3. Connect electrical connector.
4. Lower vehicle.
5. Start engine and check for leaks.
6. Check engine oil level and adjust as necessary.
LX
ENGINE - 3.5L - SERVICE INFORMATION
9 - 2249
PUMP - OIL
REMOVAL
1. Drain the cooling system. (Refer to 7 - COOLING -
STANDARD PROCEDURE)
2. Remove the timing belt. (Refer to 9 - ENGINE/
VALVE
TIMING/TIMING
BELT/CHAIN
AND
SPROCKETS - REMOVAL)
3. Remove the crankshaft sprocket. (Refer to 9 -
ENGINE/VALVE
TIMING/TIMING
BELT/CHAIN
AND SPROCKETS - REMOVAL)
4. Remove the oil pan. (Refer to 9 - ENGINE/LUBRI-
CATION/OIL PAN - REMOVAL).
5. Remove the oil pickup tube.
9 - 2250
ENGINE - 3.5L - SERVICE INFORMATION
LX
6. Remove the oil pump fasteners. Remove the oil
pump and gasket from engine.
DISASSEMBLY
1. Remove oil pump cover screws (3) and lift off cover
(4).
2. Remove pump rotors (2, 5).
3. Wash all parts in a suitable solvent and inspect
carefully for damage or wear.
CLEANING
1. Clean all parts thoroughly in a suitable solvent.
INSPECTION
NOTE: DO NOT inspect the oil relief valve assembly. If the oil relief valve is suspect, replace the oil pump.
LX
ENGINE - 3.5L - SERVICE INFORMATION
9 - 2251
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст