Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 2142
COWL EXTENSION TRIM
REMOVAL
1. Insert special tool C-4755 (from the outside in the
direction of arrow 2) under the middle of the trim
extension (2).
2. Slide trim stick up to the upper spring clip retainer,
and pry to disengage clip.
3. Slide the trim stick down to the lower spring clip
retainer, and pry to disengage clip.
INSTALLATION
1. Place trim extension (2) against cowl (1) and align
spring clips with holes on cowl.
2. Tap trim extension on to cowl (1) ensuring trim
extension (2) is properly seated.
23 - 116
EXTERIOR
LX
HOOD
TABLE OF CONTENTS
page
page
BUMPER-ADJUSTMENT
HINGE
HOOD
LATCH
LATCH RELEASE CABLE
LATCH STRIKER
ROD-PROP
SUPPORT CYLINDER
AIR INLET- FRESH AIR DUCT
HOOD-BEZEL
LX
HOOD
23 - 117
BUMPER-ADJUSTMENT
REMOVAL
1. Open and support the hood.
2. Unscrew the hood adjustement bumper(s) (1) from
the mounting hole(s) in the top of the headlamp
mounting crossmember (2).
3. Remove
the
adjustment
bumper(s)
from
the
vehicle.
INSTALLATION
1. Install the hood adjustment bumper(s) (1) into the
mounting hole(s) located in the top of the head-
lamp mounting crossmember (2).
2. Adjust the adjustment bumper(s) in or out of the
crossmember as necessary to achieve proper hood
alignment.
23 - 118
HOOD
LX
HINGE
REMOVAL
1. Open and support the hood (2) with a suitable prop
or block.
2. If the vehicle is so equipped, disconnect the upper
end of the gas support cylinder from the upper
bracket of the hood hinge (3). (Refer to 23 - BODY/
HOOD/SUPPORT CYLINDER - REMOVAL).
3. Mark the location of the hood hinge upper bracket
on the hood (2) inner panel to aid reinstallation.
4. Remove the two screws (1) that secure the hinge
to the hood.
5. Mark the hinge lower bracket location on the inside
of the front fender ledge (5) to aid reinstallation.
6. Remove the two screws (4) that secure the hinge
to the fender.
7. Remove the hood hinge from the vehicle.
INSTALLATION
1. Position the lower bracket of the hood hinge (3) to
the inside of the front fender ledge (5) on the vehi-
cle.
2. Install and tighten the two screws (4) that secure
the hinge to the fender. Tighten the screws to 28
N·m (21 ft. lbs.).
3. Position the hood panel (2) to the upper hinge
bracket on the vehicle.
4. Install and tighten the two screws (2) that secure
the hinge to the hood. Tighten the screws to 28
N·m (21 ft. lbs.).
5. If the vehicle is so equipped, reinstall the upper
end of the gas support cylinder to the upper hinge
bracket. (Refer to 23 - BODY/HOOD/SUPPORT
CYLINDER - INSTALLATION).
6. Remove the fixture being used to support the hood
for service and close the hood.
7. Adjust the hood hinge position as necessary to
achieve proper spacing and operation.
LX
HOOD
23 - 119
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст