Chrysler 300/300 Touring/300C, Dodge Magnum. Manual — part 2141
MIRROR-SIDE VIEW
REMOVAL
1. Disconnect and isolate the negative battery cable.
2. Remove the trim panel from the inside of the front
door (Refer to 23 - BODY/DOOR - FRONT/PANEL-
TRIM - REMOVAL).
3. Remove the two push pins (2) that secure the win-
dow trim molding (1) to the front door.
4. Remove the window trim molding to gain access to
the mirror fasteners.
5. Disconnect the door wire harness connector (4)
from the mirror electrical connector (2).
6. Remove the three nuts (1) that secure the outside
rearview mirror (3) to the front door.
7. Remove the outside rearview mirror from the front
door.
23 - 112
EXTERIOR
LX
INSTALLATION
1. Position the outside rearview mirror (3) to the front
door.
2. Install the three nuts (1) that secure the mirror to
the front door. Tighten the nuts to 7 N·m (60 in.
lbs.).
3. Connect the door wire harness connector (4) to the
mirror electrical connector (2).
4. Install the window trim molding (1) onto the front
door.
5. Install the two push pins (2) that secure the window
trim molding to the front door.
6. Install the trim panel to the inside of the front door
(Refer to 23 - BODY/DOOR - FRONT/PANEL-TRIM
- INSTALLATION).
7. Reconnect the negative battery cable.
LX
EXTERIOR
23 - 113
GLASS-SIDE VIEW MIRROR
REMOVAL
WARNING: Always wear eye and hand protection when servicing the mirror glass. Failure to observe these
warnings may result in personal injury from broken glass.
1. Position the mirror glass (1) so that it is facing in
toward the vehicle as far as possible.
2. Disconnect and isolate the negative battery cable.
3. Using a trim stick C-4755 or equivalent flat bladed
tool (2), release the two outer mirror glass holder
retaining clips from the mirror motor by inserting
the trim stick between the mirror glass holder and
the mirror motor.
4. Carefully pull/pry the outside edges of the mirror
glass holder (1) away from the mirror motor (2) to
disengage the remaining six mirror glass retaining
clips (3) from the mirror motor.
5. Separate the mirror glass holder from the mirror
motor and disconnect the mirror wire harness from
the heated glass electrical connector, if equipped.
23 - 114
EXTERIOR
LX
INSTALLATION
1. Connect the mirror wire harness to the heated
glass electrical connector, if equipped.
2. Position the mirror glass holder (1) to the mirror
assembly and align the eight mirror glass retaining
clips (3) to the mirror motor (2).
NOTE: Pressure must be applied equally over the
center portion of the mirror glass to fully engage
the mirror glass retaining clips to the mirror
motor.
3. Using one hand, carefully push the mirror glass
holder (1) onto the mirror motor, while at the same
time supporting the mirror housing (2) from the
backside with the other hand. Firmly push on the
mirror glass holder until all eight mirror glass retain-
ing clips are fully engaged.
4. Verify retention of the mirror glass holder by gently
pulling outward on the glass.
5. Reconnect the negative battery cable.
LX
EXTERIOR
23 - 115
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст