Chrysler New Yorker. Manual — part 299
Fig. 255 Install Input Clutch Assembly
Fig. 256 Install Caged Needle Bearing
Fig. 257 Install By-Pass Valve
Fig. 258 Install Oil Pump Gasket
Fig. 259 Install Oil Pump
Fig. 260 Install Oil Pump Attaching Bolts
300M
TRANSAXLE
21 - 69
DISASSEMBLY AND ASSEMBLY (Continued)
NOTE: Install new driveshaft retainer clips to drive-
shafts.
Fig. 261 Install Long Stub Shaft To Bellhousing
Fig. 262 Install Long Stub Shaft Snap Ring
Fig. 263 Install Low/Reverse Accumulator
Fig. 264 Install Low/Reverse Accumulator Plug
(Cover)
Fig. 265 Install Low/Reverse Accumulator Snap
Ring
Fig. 266 Accumulator Locations
21 - 70
TRANSAXLE
300M
DISASSEMBLY AND ASSEMBLY (Continued)
CAUTION: Do not handle the valve body by the
manual shaft. Damage could result.
Install both speed sensors from transaxle case (Fig.
273).
Fig. 267 Install Underdrive Accumulator and Springs
Fig. 268 Install Overdrive Accumulator and Springs
Fig. 269 Install Valve Body To Transaxle
Fig. 270 Install Valve Body Bolts (17)
Fig. 271 Install Transaxle Oil Filter
Fig. 272 Install Transaxle Oil Pan
300M
TRANSAXLE
21 - 71
DISASSEMBLY AND ASSEMBLY (Continued)
As a final check of the transaxle, measure the
input shaft end play. This will indicate when a #4
thrust plate change is required. The number 4 thrust
plate is located behind the overdrive clutch hub.
Attach a dial indicator to transaxle bell housing with
its plunger seated against end of input shaft (Fig.
274). Move input shaft in and out to obtain end play
reading. End play specifications are .13 to .64 mm
(.005 to .025 inch). If not within specifications, make
the necessary thrust plate adjustment.
DIFFERENTIAL RECONDITION
The valve body and solenoid wiring connector must
be removed from the transaxle in order to recondition
the transaxle differential. The transfer shaft cannot
be removed with the valve body in place. Refer to
Valve Body Recondition for removal procedure.
If any bearings in the differential require replace-
ment, all the bearings on the differential carrier and
transfer shaft must be replaced. The differential
adjusters must also be replaced when differential
bearings are replaced.
DISASSEMBLY
Fig. 273 Install Input and Output Speed Sensor
Fig. 274 Measure Input Shaft End Play
Fig. 275 Remove Chain Cover
Fig. 276 Remove Chain Oiler
Fig. 277 Remove Chain Snubber
21 - 72
TRANSAXLE
300M
DISASSEMBLY AND ASSEMBLY (Continued)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст