Chrysler Crossfire. Manual — part 807
REVERSE SHAFT
DESCRIPTION
The reverse shaft and reverse idler gear are housed in the rear gear train housing. Refer to Gear Train Housing in
this section.
GEARTRAIN HOUSING
DISASSEMBLY
1. Remove the transmission. (Refer to 21 - TRANSMISSION/TRANSAXLE/MANUAL - REMOVAL).
2. Remove the clutch release bearing/slave cylinder. (Refer to 6 - CLUTCH/SLAVE CYLINDER - REMOVAL).
3. Remove the sealing ring (6) from countershaft bore (4) using a screwdriver.
4. Remove the input shaft seal (1) using a screw driver.
5. Remove the countershaft bolt (5).
6. Remove the input shaft snap ring (2).
ZH
MANUAL - SERVICE INFORMATION
21 - 377
7. Remove the output shaft collared nut (5) and the
output flange (6).
8. Drive out the roll pin (8) with a suitable roll pin
punch and remove the shift actuator (7).
9. Remove the reverse gear detent plug (1). (Refer to
21 - TRANSMISSION/TRANSAXLE/MANUAL/DE-
TENT PLUG - REMOVAL).
10. Remove the rear section retaining bolts (4).
11. Separate the rear section from the front section.
Note: The countershaft, input shaft, and shift unit
can only be removed as an assembly from the rear
section.
12. Remove the four bolts(1) attaching the shifter
plate (2) to the rear section.
13. Use special tools 1126 and 938 to press the
shafts and shift unit out of the rear section of the
transmission.
21 - 378
MANUAL - SERVICE INFORMATION
ZH
14. Mount the mainshaft and countershaft together (1)
in a vise with protective jaws. Remove the shifter
(2).
15. Disassemble the rear section housing. (Refer to
21
-
TRANSMISSION/TRANSAXLE/MANUAL/
TRANSMISSION HOUSING - DISASSEMBLY).
ASSEMBLY
1. Assemble the rear section housing. (Refer to 21 - TRANSMISSION/TRANSAXLE/MANUAL/TRANSMISSION
HOUSING - ASSEMBLY).
Note: Be certain that the shift forks are aligned in
the shifting sleeves on the shafts.
2. Fit the shifter assembly (2) on to the main and
counter shafts (1).
ZH
MANUAL - SERVICE INFORMATION
21 - 379
3. Fit the rear section of the transmission (4) over the
main shaft and shift shaft. Align the reverse gear
(1) to the gear sets as shown.
4. Use the output flange (3) and the collared nut (1)
to draw in the output shaft. Remove the nut and
flange when the rear section is in place.
21 - 380
MANUAL - SERVICE INFORMATION
ZH
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст