Chrysler Crossfire. Manual — part 700
4. Install the pinch bolt (1) attaching the upper steer-
ing column to the steering gear. Tighten to 16-20
N·m (11-15 ft. lbs.).
5. Connect the clockspring electrical connector.
6. Install the column trim ring.
7. Install the speed control switch screws (1).
8. Install the multifunction switch screws (1-2).
9. Reconnect the ignition switch connector.
ZH
COLUMN
19 - 19
10. Install the instrument cluster (1). (Refer to 8 -
ELECTRICAL/INSTRUMENT
CLUSTER
-
INSTALLATION).
11. Install the clockspring screws (1). (Refer to 8 -
ELECTRICAL/RESTRAINTS/CLOCKSPRING
-
INSTALLATION).
12. Install the steering wheel bolt (1). (Refer to 19 -
STEERING/COLUMN/STEERING
WHEEL
-
INSTALLATION).
19 - 20
COLUMN
ZH
13. Install the driver airbag screws (1). (Refer to 8 -
ELECTRICAL/RESTRAINTS/DRIVER AIRBAG -
INSTALLATION).
14. Install the left lower instrument panel (2) under
the steering column. (Refer to 23 - BODY/IN-
STRUMENT
PANEL/INSTRUMENT
PANEL
ASSEMBLY - INSTALLATION).
15. Connect the negative battery cable.
ZH
COLUMN
19 - 21
INSTALLATION - RHD
WARNING: BEFORE SERVICING THE STEERING COLUMN THE AIRBAG SYSTEM MUST BE DISARMED.
FAILURE TO DO SO MAY RESULT IN ACCIDENTAL DEPLOYMENT OF THE AIRBAG AND POSSIBLE PER-
SONAL INJURY.
CAUTION: DO NOT use force as the intermediate
shaft is sensitive to the effects of side force.
1. Install the steering column.
2. Install the lower nuts on the steering column,
attaching the steering column to the lower mount-
ing surface. Tighten to 8 N·m (71 in. lbs.).
3. Install the upper bolts (1) on the steering column,
attaching it to the instrument panel support. Tighten
to 20 N·m (15 ft. lbs.).
19 - 22
COLUMN
ZH
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст