Chrysler Crossfire. Manual — part 892
DECKLID
REMOVAL
CAUTION: Use care when removing any compo-
nent that is attached to the vehicles painted sur-
face. Take the necessary precautions to avoid
paint damage while servicing the vehicle.
1. Mark an outline of the hinge on the decklid for
reassembly purposes.
2. Disconnect
the
wiring
harness
connector
(2)
attached to the decklid.
CAUTION: To avoid paint damage, have an assis-
tant help while removing the decklid bolts.
3. Remove the right side decklid retaining bolts (1).
CAUTION: To avoid paint damage, have an assis-
tant help while removing the decklid bolts.
4. Remove the left side decklid retaining bolts (1).
5. With the aid of an assistant, remove the decklid
from the vehicle. Set the decklid down on a suit-
able flat surface.
ZH
DECKLID/LIFTGATE
23 - 239
INSTALLATION
CAUTION: To avoid paint damage, have an assis-
tant help while installing the decklid.
Note: Loosely install the decklid retaining bolts
until decklid has been properly adjusted for fit.
1. With the aid of an assistant, position the decklid on
the vehicle.
2. Loosely install the two right side decklid retaining
bolts.
3. Align the decklid with the previously outlined wit-
ness marks.
4. Connect the wiring harness connector (2) to the
decklid.
5. Loosely install the two left side decklid retaining
bolts.
6. Verify fit of decklid to vehicle body. Adjust as nec-
essary.
7. Tighten decklid retaining bolts to 23 N·m (203 in.
lbs.).
23 - 240
DECKLID/LIFTGATE
ZH
BODY STRUCTURE
TABLE OF CONTENTS
page
page
GAP AND FLUSH
. . . . . . . . . . . . . . . . . . . . 242
OPENING DIMENSIONS
SPECIFICATIONS - BODY DIMENSIONS
SEALER LOCATIONS
SPECIFICATIONS - SEALER LOCATIONS
WELD LOCATIONS
SPECIFICATIONS - WELD LOCATIONS
STRUCTURAL ADHESIVE LOCATIONS
. . . . . . . . . . . . . . . . . . . . . . . . . 277
ZH
BODY STRUCTURE
23 - 241
GAP AND FLUSH
SPECIFICATIONS - BODY GAP MEASUREMENTS
FRONT AND SIDE GAP DIMENSIONS
23 - 242
BODY STRUCTURE
ZH
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст