Chrysler Crossfire. Manual — part 914
3. Install the upper lock caps (1) on the gas prop (2).
4. Verify hood lid operation.
HINGE
REMOVAL
1. Remove the hood from the hinge by removing the
upper bolts (1) then the lower bolts (2). (Refer to
23 - BODY/HOOD/HOOD - REMOVAL).
ZH
HOOD
23 - 327
2. Remove the inner front fender (1).
3. Mark the position of the hood hinge on the inner
panel.
4. Remove the bolts (2) and then remove the hood
hinge.
INSTALLATION
1. Install the hood hinge, then install the bolts (2).
Tighten to 8 N·m (70 in. lbs.).
2. Install the inner front fender (1).
23 - 328
HOOD
ZH
3. Install the hood by installing the lower bolts (2),
then installing the upper bolts (1). Tighten to 10
N·m (88 in. lbs.). (Refer to 23 - BODY/HOOD/
HOOD - INSTALLATION).
HOOD
STANDARD PROCEDURE - MOVING THE HOOD TO ITS FULLY UPRIGHT POSITION
OPENING
CAUTION: The locking button symbol “PRESS”
must be completely visible in the opening of the
gas prop rod cover tube.
1. Press the gas prop rod locking button in the open-
ing of the gas prop rod cover tube and then move
the hood to its fully upright position until locking
button catches on the detent.
ZH
HOOD
23 - 329
CLOSING
CAUTION: The locking button symbol “PRESS”
must be completely visible in the opening of the
gas prop rod cover tube.
1. Press the gas prop rod locking button in the open-
ing of the gas prop rod cover tube and then slowly
allow the hood to come down against the pressure
of the gas pressure strut.
REMOVAL
CAUTION: Use care when removing any compo-
nent that is attached to the vehicles painted sur-
face. Take the necessary precautions to avoid
paint damage while servicing the vehicle.
1. Open the hood by pulling the handle (1) and move
it to the full upright position.
23 - 330
HOOD
ZH
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст