Chrysler Crossfire. Manual — part 133
INSTALLATION - SRT
1. Clean all gasket surfaces.
2. Position the water pump with a new gasket on the
timing chain cover.
3. Install the water pump bolts in the correct positions.
Tighten the bolts to 35 N·m (26 ft. lbs.).
4. Install the oil cooler hose (3) to the water pump.
5. Install the hose clamp.
6. Install the water pump pulley (2) and bolts. Tighten
the water pump pulley bolts to 10 N·m (89 in. lbs.).
7. Install the idler pulley (1) and bolt. Tighten the idler
pulley bolt to 10 N·m (89 in. lbs.).
ZH
ENGINE
7 - 67
8. Connect the lower radiator hose (2) and coolant
by-pass hose (1).
9. Install the generator. (Refer to 8 - ELECTRICAL/
CHARGING/GENERATOR - INSTALLATION).
10. Rotate the belt tensioner counterclockwise and
install the accessory drive belt.
11. Release
the
belt
tensioner
and
remove
the
wrench.
7 - 68
ENGINE
ZH
12. Install the air pump tube assembly (1) to the
engine. (Refer to 25 - EMISSIONS CONTROL/
AIR
INJECTION/AIR
PUMP
INLET
TUBE
-
INSTALLATION).
13. Install the radiator fan. (Refer to 7 - COOLING/
ENGINE/RADIATOR FAN - INSTALLATION).
ZH
ENGINE
7 - 69
14. Install the engine cover (1). Align the engine cover
retaining clips to the rubber mounts, and push
down firmly to connect engine cover to rubber
mounts.
Note: To ease the installation of the engine cover,
apply a small amount of lubricant to the engine
cover rubber mounts.
15. Connect the negative battery cable.
16. Fill the cooling system. (Refer to 7 - COOLING/
ENGINE/COOLANT
-
STANDARD
PROCE-
DURE).
17. Start the engine and check for coolant leaks.
18. Recheck the coolant level.
RADIATOR - CHARGE AIR COOLER
DESCRIPTION
On vehicles equipped with a supercharger, there is an additional radiator used in the cooling system. The charge air
cooler radiator, is a conventional cross-flow aluminum core radiator. The charge air cooler radiator mounts in front
of the A/C condenser, and behind the front fascia. The charge air cooler circulation pump is mounted to the side of
the charge air cooler radiator. The pump is used to circulate coolant between the charge air cooler radiator and the
7 - 70
ENGINE
ZH
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст