Chrysler Crossfire. Manual — part 859
9711 RIGHT ROTATION RELAY CONTROL CIRCUIT OPEN/SHORT TO B(+) (CONTINUED)
5.
Open Rotation Relay Ground circuit
With the ignition off.
Measure the resistance of the Rotation Relay Ground circuit from the
Right Rotation Relay harness connector to the PTCM C2 harness con-
nector.
Is the resistance below 5.0 ohms?
Yes
>> Replace the Right Rotation Relay.
Perform POWER TOP CONTROL MODULE VERIFICA-
TION TEST.
No
>> Repair the Rotation Relay Ground circuit for an open.
Perform POWER TOP CONTROL MODULE VERIFICA-
TION TEST.
6.
Rotation Relay Ground Circuit
Turn the ignition off.
Disconnect the Power Top Control Module C2 harness connector.
Measure the resistance between the Rotation Relay Ground circuit and the Right Rotation Relay Control circuit at
the Power Top Control Module C2 harness connector.
Is the resistance between 60.0 - 90.0 ohms?
Yes
>> Replace the Power Top Control Module.(Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MOD-
ULES/POWER TOP CONTROL MODULE - REMOVAL).
Perform POWER TOP CONTROL MODULE VERIFICATION TEST.
No
>> Repair the Rotation Relay Ground circuit for an open.
Perform POWER TOP CONTROL MODULE VERIFICATION TEST.
ZH
CONVERTIBLE TOP
23 - 107
9710 LEFT ROTATION RELAY CONTROL CIRCUIT SHORT TO GROUND
23 - 108
CONVERTIBLE TOP
ZH
9710 LEFT ROTATION RELAY CONTROL CIRCUIT SHORT TO GROUND (CONTINUED)
•
When Monitored: With the ignition on, the Power Top Control Module continuously senses the voltage
on the Left Rotation Relay Control circuit.
•
Set Condition: When the Power Top Control Module senses high current flow on the Left Rotation
Relay Control circuit when the Power Top Switch is pressed in the direction to lower the top.
Possible Causes
LEFT ROTATION RELAY
LEFT ROTATION RELAY CONTROL CIRCUIT SHORTED TO GROUND
POWER TOP CONTROL MODULE
Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding.
Diagnostic Test
1.
Left Rotation Relay Control Circuit For Short To Ground
Turn the ignition off.
Disconnect the Power Top Control Module C2 harness connector.
Note: Check connectors — Clean/repair as necessary.
Measure the resistance between ground and the Left Rotation Relay
Control circuit.
Is the resistance above 100k ohms?
Yes
>> Replace the Power Top Control Module.(Refer to 8 -
ELECTRICAL/ELECTRONIC
CONTROL
MODULES/
POWER TOP CONTROL MODULE - REMOVAL).
Perform POWER TOP CONTROL MODULE VERIFICA-
TION TEST.
No
>> Go To 2
2.
Left Rotation Relay
With the ignition off.
Disconnect the Left Rotation Relay harness connector.
Note: Check connectors — Clean/repair as necessary.
Measure the resistance between ground and the Left Rotation Relay
Control circuit.
Is the resistance above 100k ohms?
Yes
>> Replace the Left Rotation Relay.
Perform POWER TOP CONTROL MODULE VERIFICA-
TION TEST.
No
>> Repair the Left Rotation Relay Control circuit for a short to
ground.
Perform POWER TOP CONTROL MODULE VERIFICA-
TION TEST.
ZH
CONVERTIBLE TOP
23 - 109
9721 LEFT ROTATION RELAY CONTROL CIRCUIT OPEN/SHORT TO B(+)
23 - 110
CONVERTIBLE TOP
ZH
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст