Chrysler Town & Country/Voyager, Dodge Caravan, Plymouth Voyager. Manual — part 88
Fig. 5 Push Park Rod Rollers from Guide Bracket
Fig. 6 Remove or Install Valve Body
Fig. 7 Valve Body Removed
Fig. 8 Accumulators
Fig. 9 Accumulator
Fig. 10 Low/Reverse Accumulator Snap Ring
.
TRANSAXLE
21 - 101
Tag all clutch pack assemblies, as they are
removed, for reassembly identification.
CAUTION: Do not intermix clutch discs or plates as
the unit might then fail.
Measuring input shaft end play before disassembly
will usually indicate when a #4 thrust plate change is
required, (except when major parts are replaced). The
#4 thrust plate is located behind the overdrive clutch
hub.
Attach a dial indicator to transaxle bell housing with
its plunger seated against end of input shaft (Fig. 14).
Move input shaft in and out to obtain end play
reading. End play specifications are .13 to .64 mm (.005
to .025 inch).
Record indicator reading for reference when reas-
sembling the transaxle.
CAUTION: Be sure input speed sensor is removed
before removing oil pump.
Fig. 11 Low/Reverse Accumulator Plug (Cover)
Fig. 12 Low/Reverse Accumulator Piston
Fig. 13 Low/Reverse Accumulator
Fig. 14 Measure Input Shaft End Play
Fig. 15 Pump Attaching Bolts
21 - 102
TRANSAXLE
.
CAUTION: The cooler bypass valve must be replaced
if a transaxle failure has occurred. Do not reuse old
valve or attempt to clean old valve. When installing
bypass valve, insert with O-ring end towards rear of
case.
Fig. 16 Install Tool C-3752
Fig. 17 Remove Oil Pump
Fig. 18 Oil Pump Removed
Fig. 19 Oil Pump Gasket
Fig. 20 Remove Cooler Bypass Valve
Fig. 21 No. 1 Caged Needle Bearing
.
TRANSAXLE
21 - 103
Fig. 22 Input Clutches Assembly
Fig. 23 Front Sun Gear Assembly
Fig. 24 Front Carrier and Rear Annulus Assembly
Fig. 25 Rear Sun Gear
Fig. 26 2/4 Clutch Retainer Snap Ring
Fig. 27 Remove 2/4 Clutch Retainer
21 - 104
TRANSAXLE
.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст